User manual KIDDY MAXIFIX PRO

[. . . ] A front airbag that hits the seat shell with force can cause serious injury or even death to the child!Many injuries are caused by mere thoughtlessness and can easily be avoided. Please read the instructions for use carefully before using the baby seat for the first time. Making any modifications to the child restraint system is not permitted. [. . . ] 2 3 4 5 carry position / installation on kiddyfix installation position in vehicle with 3-point seatbelt feeding position (more upright) rocking position (for sleeping) 2 Unfolding and attaching the sunshield To unfold the sunshield, pull it forward in the direction of the foot end of the baby car seat (Fig. Now hook the attachment hooks on the sunshield into the sunshield loops (I) on the rim of the shell (Fig. Now the headrest (E) or the shoulder belts (D) can be adjusted to the size of the child or the child can be lifted out of the baby car seat. Before you can adjust the headrest (E) or the height of the shoulder belts (D), the belt system must be slackened. The belt system is connected to the headrest (E), which means the belt system must not be adjusted separately from the headrest (E)! Let the height adjustment handle (P) click into place again after the headrest (E) has been adjusted. The headrest (E) must be adjusted in such a way that the shoulder belts are positioned at the same level as the baby's shoulders (Fig. Make a point off always buckling up your child when it lies in the baby car seat (A)!Now pull the centre belt (M) until the belt system fits the body of the child snugly (Fig. Place the safety belt lock tongues (C) attached to the shoulder belts over each other (Fig. Place your baby in the baby car seat and then position the shoulder belts (D) over its shoulders (Fig. Make sure that the belt system is not twisted and does not fit the child's body too tightly. 1 Installation with the vehicle restraint Read up all the necessary information about the use of child restraint systems in your vehicle owner's manual. The kiddy maxifix pro child restraint system can be installed on any seat of vehicles equipped with a 3-point belt system (Fig. * The passenger airbag must be deactivated or another seat must be used. 2 Installation steps with the vehicle restraint Place your kiddy facing the rear on a seat without an active front airbag and with a 3-point belt (Fig. Pull the vehicle restraint out and feed the lap belt through both lap belt guides (K) and press the safety belt lock tongue with a clearly audible click into the belt clip (Fig. Now place the shoulder belt around the baby car seat (A) and feed it through the diagonal belt guide (O) at the rear of the kiddy seat (Fig. Swivel the carry handle (G) to the rear against the vehicle backrest and make certain that the carry handle buttons (J) lock into place (Fig. With this the automatic recoiling of the belt can be blocked, which makes a more secure installation of the kiddy seat possible. Read your vehicles' owner manual for more information on this feature or ask your authorised workshop or dealer. The kiddy maxifix pro child restraint system can be installed in combination with the kiddyfix ISOFIX platform on any seat equipped with ISOFIX attachments. [. . . ] Plastic parts can be cleaned with a mild detergent or with a damp cloth. After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damages and replaced at no charge if deemed necessary. Fabrics: All of our fabrics meet the highest standards regarding colourfastness against UV radiation. This is not due to defective material but to normal wear and tear, which is not covered by the warranty. [. . . ]