User manual KIDDY MAXI PRO

[. . . ] - There is a 3-point vehicle belt available, which is approved in accordance with ECE 16 or comparable standards. Read through the directions for use carefully before fitting the kiddy maxi pro seat for the first time. It is forbidden to make any changes whatsoever to the child restraint systems. If you experience difficulties please contact your specialist dealer or the manufacturer directly. [. . . ] Make sure you never position the seat shell on sloping ground and avoid putting it down on raised items (table, baby changing unit, etc. If the sun canopy is not needed, it can be fixed using the spring mounted clamp under the pan rim (fig. Below are instructions on how to dismantle or assemble the sun canopy: Now you can pull the clamp bracing (fig. 1 Choice of seat Using the child car seat In driving direction Opposite of driving direction With 2-point belt With 3-point belt With front airbag Some vehicle manufacturers enable the front airbag to be switched off. Obtain information on using seat pans from your vehicle manual or consult your authorised repair shop. The seat pan is not suitable for seats which are only fitted with a 2-point lap belt. In vans the seat pan should be mounted on the seat that has the easiest access in the event of a rescue operation. After looking through the vehicle manual as well as selecting the appropriate seat, the seat pan can be fitted in the vehicle as described in the following section. Position the seat pan backwards facing the vehicle seat and turn the carrying frame in the position of drive operation (fig. Direct the lap belt of the vehicle's own 3point belt systems through both lap belt guides on the seat pan and let the belt tongue lock in place. Guide the shoulder belt of the vehicle's own 3-point belt systems on the back of the baby seat pan and thread this between the blue belt guide and the guide on the seat pan (fig. The automatic roll-up of the vehicle's own belt system can be disabled. 1 Height adjustment of 5-point belt system and head support The kiddy maxi pro has a 5-point belt system, which guarantees optimal protection for your baby in the seat pan. In order to guarantee the best possible safety for your baby with the 5-point belt system, this must be adapted accurately to the body size. By pressing the central belt adjustment, the area marked in red (press) in front on the cover of the seat pan and at the same time pulling on both shoulder belts you can loosen the 5-point belt system (fig. In order to adjust the shoulder belt in height, you must move the head support in the direction required by means of the yellow head support adjustment on the back of the seat pan (fig. 1) The head support adjustment must be loosened by bringing it out slightly from its locked in position and at the same push it up or downs into the required position. The head support must be set so that the shoulder belt is at shoulder height of the baby or slightly above (fig. Please make sure that your baby is always wearing a seat belt in the seat pan. Place the child in the seat pan and then guide the shoulder belt over your baby's shoulder (fig. To take your baby out open the 5-point belt system by pressing the red button on the front of the buckle and loosen the belt (see chapter 5. 3) Check that this is fastened securely by pulling on both shoulder belts and the buckle at the same time. [. . . ] Make sure that when feeding the belt straps in the lower area of the seat pan, these are fed first through the outer slot and then through the inner slot. The belt strap must be inside the seat pan and fastened with the belt tongue (fig. After an accident resulting from a speed of over 10km, the seat pan must be checked by the manufacturer for possible damage and if required, replaced. Guarantee For this seat pan we offer a 2 year guarantee for manufacturing or material defects. [. . . ]