User manual KIDDY EVOLUNA 2

[. . . ] Kiddy also allows the installation on Isofix vehicle seats that are listed in the vehicle type list. De/typelist_isofixbase Never fix the Evoluna i-Size 2 with the vehicle seat belt!It is important to take note that you may never use the Evoluna i-Size 2 seat with an active front airbag!A front airbag that hits the infant carrier with force can cause serious injury or even death to the child! [. . . ] This comfort inlay may only be used for babies up to the age of 6 months (fig. To remove the inlay, open the buckle and remove the insert from the shoulder belts. 3 Using the sunshade To extend the sunshade pull the hood towards the foot end of the car seat. To attach the sunshade, insert the two joints into the respective guide rail until they are locked (fig. 1 Loosening the belt system Turn the carry handle in to the carry position. Before you can adjust the height of the shoulder belts, the belt system must be loosened. For this purpose, keep the central adjuster pressed in the front under the seating area (fig. 2 Adjusting the height of the belt system Open the front cover at the head end of the infant carrier by slightly pressing the hooks upward. The optimum height position of the shoulder belts is reached when the belts are at the babies shoulder height (fig. Lock the height adjuster handle back into place after you have finished. Please make sure that the belt system is not twisted or does not become lodged!3 Buckling / unbuckling of the baby Always buckle up your child when it is in the infant carrier!Place your baby in the infant carrier and then position the shoulder belts over its shoulders (fig. Place the safety belt lock tongues attached to the shoulder belts over each other (fig. Now pull the central belt until the belt system fits the body of the child snugly (fig. Make sure that the space between the belts and your child is no more than the width of a finger (ca. To unbuckle your baby loosen the shoulder belts as described in point 6. 1 Seat selection Read up all the necessary information about the use of child restraint systems in your vehicle owner’s manual. In connection with the Isofix platform, the Evoluna i-Size 2 may be used on all i-Size vehicle seats. Kiddy also allows the installation on Isofix vehicle seats that are listed in the vehicle type list (fig. The latest version of the vehicle type list is always available for download at www. Rear-facing child restraint systems may never be used with an activated front airbag (fig. [. . . ] 3 Cleaning the belt system The belt system can be cleaned with a damp cloth. Steps to take after an accident After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damage and replaced if necessary. Warranty For this child restraint system we extend a warranty against defects in materials and workmanship for up to two years. The warranty covers child restraint systems that have been handled properly and are returned in a clean and orderly condition. [. . . ]