User manual KIDDY COMFORT PRO

[. . . ] Please thoroughly read the entire instruction manual before installing the child restraint system for the first time. For children weighing 9­18 kg, the child restraint system must always be used with the appropriate impact shield. Otherwise the seating position and protection would be impaired in the event of an accident. Use the child restraint system only for weight classes I to III (from 9 kg up to 36 kg maximum). [. . . ] The correct headrest setting is achieved when the head of your child lies at the midline of the headrest. To adjust the head and shoulder supports, grasp the yellow height adjustment handle on the back of the headrest and pull it out gently, while simultaneously raising or lowering the headrest to the desired height (Fig. After adjusting the height, lock the headrest again in the nearest available position. You can check to see that the headrest is firmly locked in place by gently pressing down on it. 3 Adjusting the reclined position (AG I only) The kiddy comfort pro is equipped with a reclined position that ensures comfortable and safe seating particularly on longer trips. The reclined position may be used only for children in Age Group I (9­18 kg). To set the reclined position, first unfasten your vehicle's own restraint system. Pull the kiddy comfort pro forward far enough so that the black support bar found on the back of the child seat can be unfolded (Fig. The support bar must rest against the vehicle's seatback in its unfolded position. This position is reached when the seatback of the child seat rests again the seatback of the vehicle (Fig. Unfasten the vehicle restraint, change the position of the support bar and the seatback, and then secure your child (the child restraint system) again. 4 Adjusting the seat bottom (thigh support) You can achieve significantly better seating comfort for your child by adjusting the thigh support, which can be set in four positions (Fig. Step 2: Pull the extension out to the desired position and lock it into place. Check to see whether your kiddy is adjusted to the size of your child (Section 5). The kiddy comfort pro is secured with the three-point vehicle restraint using the belt channel on the impact shield (Fig. For Age Group I, your kiddy comfort pro may be used only with the appropriate impact shield. Once the child is seated, slide the impact shield into the slots on the seat (Fig. Slide the impact shield back so that it rests right on your child's tummy. Then pull your vehicle's three-point restraint out enough so that it goes around your kiddy and can be directly fastened in your vehicle's own seatbelt lock (Fig. Make sure that the seatbelt tongue locks securely in place with a noticeable "click. If your kiddy comes with toy figures, these should be placed over the body shield for simpler belt fastening (Fig. Next, thread the lap belt through the red belt retainer on the impact shield, then tighten the belt (Fig. [. . . ] 2 Cleaning the toy figures The toy figures can be cleaned with a damp cloth. 3 Cleaning plastic parts The plastic parts can be cleaned with a mild cleanser or with a damp cloth. After an accident with an impact speed greater than 10 km/h, the child restraint system must be sent back to the manufacturer without fail, to be checked for possible damages and replaced at no charge if deemed necessary. For the kiddy comfort pro we extend a warranty against defects in materials and workmanship for up to two years. [. . . ]