User manual KIDDY CLICK N MOVE

[. . . ] Lock the emergency brake before seating or removing your child (in the child seat). Never hang bags, purses or other items on the handle, as this can impair the stability and therefore safety of your "kiddy click`n move". Never use your "kiddy click`n move" on stairs or escalators. using the "kiddy click`n move" as a toy is strictly prohibited. [. . . ] The child seat) in or remove your child from your "kiddy click`n move". To release the brake, lift up on the brake lever with the tip of your foot. Never leave your child unattended in the travel system, even if the brake is set!Insert both child seat adapters into the travel system until they snap in place. Check to make sure that the adapter locks are open (levers are in the position indicated in red). Make certain that your child is properly secured in the infant carrier and that the brake is engaged!Always check to see that the adapters in the child seat are locked by observing that the levers on both adapters are now in the upper position (indicated in yellow). 2 Removing the infant carrier To be able to remove the seat, press down on both levers on the adapters (red position). 3 Removing the adapters Press the button on the inner side of the adapter, and pull the adapters up out of the frame. Using the pushchair seat The pushchair seat in intended for children weighing approximately 8 to 15 kg (6 months to 4 years)!When you want to use the pushchair seat with your "kiddy click`n move", you must first remove both child seat adapters. Press the button on the inner side of both adapters, and pull them up out of the frame. 1 Inserting and removing the pushchair seat Set up your "kiddy click `n move" as described in Section 4. Place the the pushchair seat on the frame, and check ensure that it is securely locked in place. To remove the pushchair seat, press and hold in both grey buttons on the side of the pushchair seat, and then pull it up. 2 Securing your child To ensure the safety of your child, the pushchair seat is outfitted with a five-point restraint system. Always use the restraint system whenever you transport your child in the pushchair seat. To do this: Slide the belt cushion up so you can see the belt adjustors, and move them to fit your child. There should be at most a finger-width of slack between the belt and your child. 1 Safety bar For smaller children, the safety bar should always be used in combination with the five-point belt restraint system. [. . . ] If a wheel begins squeaking, spray a small amount of silicon oil or place a drop of fine machine oil on the axle. To clean your "kiddy click`n move", use a mild soap and water. 2 Pushchair seat Check the seat regularly for splitting seams or other damage. The seat cover is removable and can be washed with delicates at 30°C. [. . . ]