User manual KETTLER BALTIC

[. . . ] Before assembling or using the table-tennis table, please read the following instructions carefully. They contain important information for use and maintenance of the equipment as well as for your personal safety. [. . . ] Damaged or worn components may endanger your safety or When folded up, the table-tennis table presents a large surface Replace worn or damaged components immediately and remove the table from use until this has been done. The table-tennis table may be pushed only into the transport po- Sition because there is otherwise a danger of injury. Correct repairs, alterations to the design (removal of original parts, addition of other components etc. Do not use the table-tennis table until it has been fully and cor For practising without a partner, the table halves can be folded Ensure that table-tennis tables which are not weatherproof are For more information on the sport of table-tennis, you are re- Keep them well away from direct sources of heat. Should the surface become warped, lay the table on a level surface for a few days. Do not cover it with plastic foil, under which condensation may Do not use corrosive or abrasive materials to clean the equip- Ensure that such materials are not allowed to pollute the environment. Its useful life please dispose of this article correctly and safely (local refuse sites). The fastening material required for each assembly step is shown The equipment must be assembled with due care by two adult Ensure that you have received all the parts required (see check Should you have any cause for complaint, please contact your KETTLER dealer. Before assembling the equipment, study the drawings carefully Use the fastening material exactly as instructed. Bolt all the parts together loosely at first, and check that they And carry out the operations in the order shown by the diagrams. Please note that there is always a danger of injury when work- Ing with tools or doing manual work. Ensure that your working area is free of possible sources of dan- Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts completely against resistance (locking device). Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced. For technical reasons, we reserve the right to carry out prelimi- Ger, for example don't leave any tools lying around. [. . . ] Hold the table firmly with one hand, press the left-hand lock and lower the table-half slowly into position. Continue to press the lever during the first part of the upward motion. [. . . ]