User manual KETTLER ALANA

[. . . ] I Please care for the fact that the tricycle is only used on safe ground. I In case of a sudden and/or strong turn of the handlebar the tricycle could be caused to tip. I The tricycle must not be connected with other vehicles, sports or similar devices and not be driven/pulled by them. Never subject your child on the tricycle to speeds exceeding walking pace! [. . . ] I Although dangerous situations are unlikely to occur if the toy is used correctly, children at play should, if possible, be supervised. I Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary. I Please bear in mind that there is always a danger of children injuring themselves while using swings, climbing frames, toy vehicles or similar equipment. I When children are at play, situations may arise which cannot be predicted by the manufacturer and for which we cannot be held responsible. I Before use, always check all screws and plug-in connections as well as respective safety devices fit correctly. I Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil every two or three months. I For models with push bars: Always ensure that the push bar fits correctly in the adaptor, and locks. The push bar is intended for adult use only, do not pass responsibility for children on to other children. For free play time take the push bar off for safety reasons. Assembly of the toy vehicle I The toy vehicle must be assembled carefully by an adult person. Assemble the vehicle in the exact sequence shown by the letters in the diagrams. This is essential for the safe function and use of the scooter I Please note that there is always a danger of injury when working with tools or doing manual work. I Ensure that your working area is free of possible sources of danger, for example don't leave any tools lying around. Always dispose packaging material in such a way that it may not cause any danger. There is always a risk of suffocation if children play with plastic bags!I Bolt all the parts together loosely at first, and check that they have been assembled correctly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tighten nuts completely against resistance (locking device). Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced. I The grips can be pushed onto the handlebars more easily if they are first soaked in warm water. I Please keep original packaging of this article, so that it may be used for transport at a later date, if necessary. I For technical reasons, we reserve the right to carry out preliminary assembly work (e. g. [. . . ] KETTLER NEITHER ASSUMES NOR AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH SUCH PRODUCTS. KETTLER® International Inc. 1355 London Bridge Road · Virginia Beach · Virginia VA 23453 USA For parts or service ONLY call 1-866-804-0440 or send e-mail to: parts@kettlerusa. com call (866) 804-0440 fax (757) 563-9273. www. kettlerusa. com info@kettlerusa. com The manufacturer reserves the right to make changes reflecting product or other technical advances. The content of these instructions is accurate at the date of printing. [. . . ]