User manual KERO 360

[. . . ] Notice d'utilisation: Lisez attentivement la notice jointe à l'appareil. Prepare the heater for use by carrying out the instruction in the following order: Pull the bottom of the grid facing you. Open the lid of the fuel tank compartment and remove the material which protected it during transport. [. . . ] Use a pump to fill the tank with liquid combùstible for mobile heater. Keep on filling until the level of fuel reaches Presence of Iiquid combustible for mobile heater will make move the reading on the gauge into the black. Turn the tank over, so that the filler orifice is facing downwards, and carefully put it back into its place. When the level of fuel in the tank goes down, the fuel gauge will indicate this. The fuel in the tank will be completely used about three hours burning after the fuel gauge reached the halfway level. If the heater is not level, the automatic shut-off device maybe prevented from working. The automatic shut-off device (in case of knocks) is ready to work Do not try again and" ventilate the room. The first time you use a wick, let it absorb liquid combustible for mobile heater for about one hour. Only use liquid combustible for mobile heater with the aromatics removed, with a flashpoint above 61 and free of any impurities, in order to ensure that your wick lasts for a long time. If you find that the wick ls abnormally hard, if it is blocked or burning is abnormal, have it replaced by a qualified specialist, for example, the supplier of your heater. Before you Iight the heater, check the following points: the combustion cylinder must be proprely positioned. Make it rotate pushing the lever from left to right and make sure it is correctly fitted. When you use the heater for the first time, odours may persist for a certain time after lighting. This is normal, as oil and protective grease in the heater have to be burnt off. Slowly push the ignition lever downwards until it stops and keep the knob downwards. After having carried out the ignition procedure, there may be some white smoke coming out of the ignition zone, without the heater being lit. [. . . ] If the combustion cylinder has not had time to cool down, Iighting the heater again may result in odours being given off. Ln case of problems, check here before you take your heater to your dealer. Batteries may be fiat orweak Ignition plug filament may be bent or broken Wick ls toc low, too high or incorrectly installed Bumer is not operly positioned Liquid combustible for mobile heater is of poor quality or contaminated with water Wick may be dirty Wick guide assembly may be damaged Wick is not correctly seated in wick assembly Use wick adjustment knob to adjust wick for proper exposure. [. . . ]