User manual KENWOOD KRF-V7020

[. . . ] KRF-V7020/V6020/V5020 (En/T) 1 AUDIO VIDEO SURROUND RECEIVER KRF-V7020 KRF-V6020 KRF-V5020 INSTRUCTION MANUAL KENWOOD CORPORATION This instruction manual is for some models. Model availability and features (functions) may differ depending on the country and sales area. About the supplied remote control (RC-R0508) . . Compared to standard remote controls, the remote control supplied with this receiver has several operation modes. These modes enable the remote control to control other audio/video components. [. . . ] the SOUND key twice. ) L R SW Selecting a source using the AUDIO key on the remote control (RC-R0508) 1 2 3 4 "CD" ("CD"*) "TAPE" or "MD" ("TAPE"*) TUNER "PHONO"("PHONO"*) A TREB +4 AUTO MEMO. STEREO ST. TUNED 2 Use the MULTI CONTROL (TUNING/SKIP) to adjust the sound quality. · The bass and treble levels are adjustable from -10 to +10 in 2 step increments. · The adjustment item is displayed for approximately 8 seconds. · If you used the remote control (RC-R0508) to perform the above setting, press the VIDEO key at this point to turn off the remote control's own adjustment mode. In this case, the input source is not switched. Selecting a source using the VIDEO key on the remote control (RC-R0508) 1 "VIDEO1" ("VCR1"*) 2 "VIDEO2" ("VCR2"*) 3 "DVD 6ch" · When selecting an input source by using the remote control (RCR0710), press the desired input selector key. · "VIDEO 2" can be selected as an input source only if the VIDEO 2/ MONITOR setting is "VIDEO 2". 8 * Once setup codes are registered in the remote control (RC-R0508), the input name display changes according to the name of the registered component. Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears instead of "VIDEO 1". RC2 · When using the remote control (RC-R0508) after initial setup, any inputs that have not been registered with a setup code are deleted from the cyclic list. RC4 · The INPUT SELECTOR on the front panel of the receiver always cycles through all inputs. Once-touch low frequency emphasis (bass boost) The following adjustments are possible if the receiver is in the stereo mode. · Press the key once to select the maximum (+10) low frequency emphasis setting. · This key does not function when the receiver is in the sound quality or ambience effects mode. 2 Start playback from the selected source. 3 Use the VOLUME CONTROL (VOLUME) to adjust the volume. Switching back to the previous setting Press the BASS BOOST key again. Operations Adjusting the tone Normal playback Recording KRF-V7020/V6020/V5020 (En/T) 16 Muting the sound MUTE lets you mute the sound of the speakers. Press the MUTE key. SP Recording audio VIDEO 2 / MONITOR A MUTE L R SW Blinks CD Recording a music source INPUT SELECTOR · On the KRF-V5020, this selection can be made using the control on the receiver as well. To cancel Press the MUTE key again so that the "MUTE" indicator goes off. · Muting can also be cancelled by adjusting the volume. When recording a music source, switch the VIDEO2/MONITOR setting to "MONITOR". 8 1 Use the input selector to select the source (other than "TAPE") you want to record. 3 Start playback, then start recording. SOURCE DIRECT playback (analog sources only) Use this function to pass the source material direct to the amplifier, bypassing any audio processing. TUNED Copying tapes When copying tapes, switch the VIDEO2/MONITOR setting to "MONITOR". 8 MONITOR = TAPE copying 1 Press the VIDEO 2/MONITOR key. AUTO SOUND AUTO MEMO. TUNED Operations · Either press the LISTEN MODE, SOUND, and SETUP keys, or switch to another input source to cancel SOURCE DIRECT playback. STEREO MONITOR To cancel Press again. · If SOURCE DIRECT playback was activated when using a surround mode, cancelling it reactivates the previous surround mode. 2 Use the input selector to select a source other than "TAPE". [. . . ] ±10 dB (at 100 Hz) TREBLE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ±10 dB (at 10 kHz) Caution : Read this page carefully to ensure safe operation. KRF-V7020/V6020/V5020 (En/T) VIDEO section VIDEO inputs / outputs VIDEO (composite) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Vp-p / 75 27 FM tuner section Tuning frequency range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 87. 5 MHz ~ 108 MHz Usable sensitivity (DIN, 75 ) MONO . . . . . . . . . . . . . . . . . . . . [. . . ]