User manual KENMORE 665-7436

[. . . ] Your purchase has added value because you can depend on Sears HomeCentral ® for service. With over 2, 400 Service Technicians and access to over 900, 000 parts and accessories, we have the tools, parts, knowledge and skills to back our pledge: We Service What We Sell. sears Maintenance Agreements Your Kenmore ®appliance is designed , manufactured and tested to provide years of dependable operation. Provides an annual Preventive Maintenance Check, at your request, to ensure that your appliance is in proper running condition. [. . . ] Local utilities recommend avoiding heavy usage of energy at certain times of day. Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed. If your home is equipped with a water softener, you may want to avoid starting the dishwasher during the regeneration of the softener, since this may contribute to poor wash performance. Or press START to use the same cycle and options as the previous cycle, NOTE: If the last cycle you completed was a rinse cycle, the dishwasher will run the last full wash cycle and options that you selected when you press StarL A "O" shows what steps are in each cycle. IMPORTANT: Typical cycles may take several hours depending on cycle selected and water temperature. Water that is too hot can make some soils harder to remove and cause certain detergent ingredients not to function. If your water heater is located far from the dishwasher, it may be necessary to run the hot water at the faucet closest to the dishwasher to minimize the amount of cold water in the water line. Before starting the dishwasher to clear all Normal Wash Use this cycle for loads with normal amounts of food soil. During the first minute of a cycle This cycle uses a light wash and gentle dry. After the first minute of a cycle Your dishwasher starts a 2-minute drain (if needed). Quick Rinse Use this rinse cycle for rinsing dishes, glasses, and silverware that will not be washed right away. *if the incoming water temperature is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time and heat as needed. IMPORTANT: If Lock On is selected, turn off the lock (see Lock On section in "Option Selections"), or the Start/Resume light will continue to flash. If you change your mind, press the option again to turn the option off. For example, you can press an unheated drying option any time before drying begins. Press START/RESUME to use the same cycle and option(s) as the previous wash cycle. NOTE: If the last cycle you completed was a rinse cycle, when you press START/RESUME, the dishwasher runs the last full wash cycle and options. Hi Temp Wash Select this option to heat the water to 140°F (60°C) during parts of the cycle. Use this option for heavier than normal-soiled Sani Rinse Select this option to raise the water temperature in the final rinse to approximately 155°F (68°C). This high-temperature rinse sanitizes your dishes and glassware in accordance with the NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. nOTE: Sani Rinse is an option with Pots Pans , Heavy Wash and Normal Wash. [. . . ] Home water pressure should be 20 to 120 psi (138 to 828 kPa) for proper dishwasher fill. A booster pump on the water supply can be added if pressure is too low. NOTE: To remove spots and film from dishes, try a white vinegar rinse. Vinegar is an acid, and using it too often could damage your dishwasher. [. . . ]