User manual KENMORE 625.345200

[. . . ] This warranty gives you specific legal rights, and you may have other rights which vary from state to state. 817 WA, Hoffman Estates, IL 60179 PARTS INCLUDED Your Kenmore Faucet Water Filter con sists of the following parts. [. . . ] (2 required on some faucets) gasket, 15/16" dia. SINK FAUCET collar adaptor, threaded end up 7/8" dia. C 13/16­27 UNS internal SINK FAUCET gasket, 3/4" dia. 4, page 5, fasten the faucet filter to the adaptor(s) installed in step 3. You can also turn the filter so the control is to the left, or position as otherwise desired. IF YOU HAVE QUESTIONS, CALL TOLL FREE, 1-800-426-9345 continued 4 CONNECT THE FILTER TO A FAUCET 5. CHECK FOR LEAKS: Open the cold water faucet and adjust to a medium flow. Check for leaks around the collar and adaptors, and tighten if needed to stop the leak. PURGE FILTER CARTRIDGE: With the cold water faucet still open, turn the water diverter control on the filter, to route water through the filter cartridge (FIG. Allow water to run through the filter for about 1/2 minute to purge small, harmless carbon particles from the cartridge. FIG. 4 collar gasket, 15/16" dia. water diverter control (closed) USING YOUR FAUCET WATER FILTER Note: Be sure to purge a new filter cartridge as instructed in step 6, above. JOpen the cold (never use hot) water faucet and adjust to a medium flow. 5 filtered water outlet JHold a glass, cup, pitcher, or other container under the filtered water outlet. JOpen the water diverter control on the filter, and catch the water in the container. [. . . ] Discard the first few cupfuls of filtered water after changing the cartridge. ­ Cold water faucet not opened and/or water diverter control not turned to direct water into the filter. 6 REPAIR PARTS KENMORE FAUCET WATER FILTER MODEL NO. 1 2 D PART NUMBER 42­34522 7154787 7183150 DESCRIPTION OF PART Filter Cartridge O­ring Seal, Cap 2 ­1/4" I. [. . . ]