User manual KENMORE 110.8708

[. . . ] Master Protection Agreements Congratulations on making a smart purchase. Your new Kenmore ®product is designed and manufactured for years of dependable operation. But like all products, it may require preventive maintenance or repair from time to time. That's when having a Master Protection Agreement can save you money and aggravation. [. . . ] Use a wrench to finish turning the legs until the diamond marking is no longer visible. Place a carton corner post from dryer packaging under each of the 2 dryer back corners. Slide the dryer on the corner posts until it is close to its final location. The dryer vent must fit over the dryer exhaust outlet and inside the exhaust hood. Use caulking compound to seal exterior wall opening around exhaust hood. Do not use duct tape, screws or other fastening devices that extend into the interior of the vent to secure vent. Use a wrench to adjust the legs up or down and check again for levelness. To protect the floor, use a large flat piece of cardboard from the dryer carton. You can change your door swing from a right-side left-side opening, if desired. NOTE: For ease of installation, you may want to use 2 or more people to remove and reattach the dryer door. Place a towel or soft cloth on top of the dryer or work space to protect the surface. Lay the dryer door on a flat, protected surface with the inside door assembly facing up. Remove the 5 screws to release the outer door assembly from the inner door assembly, as indicated below. Move hinge to the other side and reattach with the 4 screws removed in Step 3. Make sure Iocator pins line up in holes and drive the top 2 screws in place first to help drive Iocator pins into proper location. Rotate the window assembly 180° and reattach the intermediate door, hinge shield and hinge hole cover with the 6 screws removed in Step 2. To fit correctly, the inside door assembly edge is completely inside the outside door assembly edge. Remove the 2 plug screws and plastic plugs, and insert them in the original screw holes on the opposite side. If there is an extra part, go back through the steps to see which step was skipped. Remove the blue protective film on the console and any tape remaining on the dryer. " Wipe the dryer drum interior thoroughly with a damp cloth to remove any dust. Align the door by placing the locating tabs on the hinge with the locating holes on the dryer front panel. [. . . ] Large loads may require pressing and holding the Start button for 2-5 seconds. If the dryer hasn't been used for a while, there may be a thumping sound during the first few minutes of operation. Is a coin, button, or paper clip caught between the drum and front or rear of the dryer?Are the four legs installed, and is the dryer level front to back and side to side? [. . . ]