User manual KELVINATOR KCT300

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. From the Electrolux Group. The Electrolux Group is the world's largest producer of powered appliances for kifchen, cleaning and outdoor use. [. . . ] Take care of operating the freezer at a position of thermostatic control so that the inside temperature can never go above -18 °C, since temperature higher than this can deteriorate frozen foods. It is practical to make sure of faultless operation of the appliance daily so as to notice possible failure in time and prevent deterioration of frozen foods. Maintenance Defrosting Bleeding part of the moisture of cooling chambers in form of frost and ice goes with the operation of the appliance. Thick frost and ice has an insulating effect, so it reduces cooling efficiency as the temperature increases in the cooling chambers and they need more energy. At this type of appliance defrosting the cooling plate of the refrigerator is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular 59 GB intervals for more or less time - during this cooling is interrupted - the temperature of the cooling plate goes above 0 °C due to interior heating load of the compartment, so defrosting occurs. When the surface temperature of the cooling plate has reached +3 - +4 °C the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet leaded through the back into the evaporative tray maintained on the top of compressor and evaporates due to its warmth. Check and clean the outlet of melting water coming during defrosting regularly - a label inside the appliance warns you for this. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the melting water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of the refrigerator and freezes to it. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being nocurrent. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Solution Set the thermostat knob to higher position. Place the products in a way so that cold air could circulate among them. Problem It is too warm refrigerator. in the It is too warm in the freezer. Possible cause Thermostatic control can be set wrongly. The melting water outlet flows not into the evaporative tray above the compressor. The thermostatic control can be set wrongly. Water flows at the back plate of the refrigerator. There are too much frost and ice. The compressor operates continually. The thermostatic control is set wrongly. The appliance is in too warm place. The appliance does not work at all. Indicator lamps do not give light. Plug is not connected to the mains socket properly. (Try to connect another appliance into it. ) The appliance is not supported properly. Clean the outlet. [. . . ] Performing the guarantee means that the appliance is returned to the condition it was in before the defect occurred. So as to avoid more severe damage, the defect must be brought to our attention immediately. Applying the guarantee is subject to the consumer providing proof of purchase showing the purchase and/or delivery date. The guarantee will not apply if damage caused to delicate parts, such as glass (vitreous ceramic), synthetic materials and rubber, is the result of inappropriate use. [. . . ]