User manual JWIN JX-CD418 INSTRUCTION MANUAL

[. . . ] Please note If the unit is connected to the mains, the Power light will come in. Switching on Mains power The unit comes with a mains power cable. Batteries Always remove the mains power lead from the unit for battery operation. Make sure the (+) and (-) ends of the batteries are positioned as shown outside the battery door. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. [. . . ] If a disc is deeply scratched or too dirty, it may not play. # Once you have loaded a CD/CD-R/CD-RW, press the CD Play/Pause button. The display shows the track currently playing and the Play/Pause light comes on. The FM ST. /RW indicator light comes on to indicate ]CD-RW^ is playing. Skip forward or back through tracks To select the next track, press >> Skip/ Search. If you are on the last track of the disc, the player will move to track 1. To go back to the beginning of the current track press << Skip/Search once. To play a particular track, load the disc in the CD player and press >> Skip/Search until the track number you want is shown in the display. To resume play, press the Play/Pause button again. Playing CDs Programmed track selection You can set the unit to play a selection of tracks from your disc. Press >> Skip/Search or << Skip/Search to display the track number you want. Now press << Skip/Search or >> Skip/ Search to display the next track you want. The first programmed track is displayed and your selection starts playing. After all the programmed tracks have been played, the CD player stops automatically and your programmed tracks are cleared. Please note if, during track selection, you press the Play/ Pause button before pressing the Program button, the track will not be stored in the program memory and the disc will start playing from the first selected track. Repeat disc play You can set your CD player to repeat play a single track, the whole disc or your programmed track selection. To repeat a single track Press << Skip/Search or >> Skip/Search to select a track. The Repeat indicator will flash to indicate " track repeat" is on. The selected track will play continuously until you press Stop or press the Repeat button twice more. The Repeat indicator will light to indicate " disc repeat" is on. The entire disc will play continuously until you press Stop or press the Repeat button once more. Use of controls, adjustments or procedures not listed in this guide may result in hazardous exposure. $ Using the cassette player Inserting/removing cassettes Set the Function Selector to Tape. Slide the cassette tape into the door with the exposed section of tape facing upwards. [. . . ] In most cases, you can remove these ridges by fast forwarding the tape from one end to the other in your cassette player. Avoid C-120 cassettes, as the tape material deteriorates much quicker. Do not touch the surface of the tape. Cleaning CDs Use a soft cloth to wipe off any fingerprints and dust from the disc surface. Small dust particles and light stains will not affect reproduction quality. [. . . ]