User manual JVC UX-G300

[. . . ] MICRO COMPONENT SYSTEM UX-G300 --Consists of CA-UXG300 and SP-UXG300 IMPORTANT for the U. K. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. [. . . ] DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishings. DON'T use makeshift stands and NEVER fix legs with wood screws--to ensure complete safety always fit the manufacturer's approved stand or legs with the fixings provided according to the instructions. DON'T allow electrical equipment to be exposed to rain or moisture. ABOVE ALL ­ NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case --this could result in a fatal electrical shock. ; ­ NEVER guess or take chances with electrical equipment of any kind--it is better to be safe than sorry! Listening to Digital Audio Player Front view Digital Audio Player Setting the Clock Without setting the built-in clock, you cannot use Daily Timer and Sleep Timer. · "0:00" flashes on the main display until you set the clock. Press to activate the clock setting mode. 1 1 Tuner section FM tuning range: 87. 50 MHz - 108. 00 MHz AM (MW) tuning range: 522 kHz - 1 629 kHz Stereo mini plug cord (not supplied) To audio output (or headphone out, etc. ) 1 2 3 4 Turn the volume to minimum. 2 · If you have already adjusted the clock before, press the button repeatedly until the clock setting mode is selected. or 2 or Press repeatedly to select "AUDIO IN. " Start playing the Digital Audio Player connected. Adjust the volume. · To exit from the clock setting, press CLOCK/TIMER as required. · To go back to the previous step, press CANCEL. Setting the Sleep Timer When the System is on, press repeatedly to specify the time (in minutes) as follows: To Adjust the Audio Input Level If the sound from the Digital Audio Player connected to the AUDIO IN jack is too loud or too quiet, you can change the audio input level through the AUDIO IN jack (without changing the volume level). Press and hold for more than 2 seconds while "AUDIO IN" is selected as the source. You can select one of three levels as follows: The SLEEP indicator lights up. · To check the remaining time until the System shuts off, press once. 3 1 Adjust the hour then the minute for on-time. 3 Select the playback source--"TUNER-FM, " "TUNER-AM, " "DISC, " "AUDIO IN, " or "USB. " 4 For "FM/AM": Select a preset channel. (For MP3/WMA: Select the group, then the track number. ) For "AUDIO IN": Make the connected device ready for playback. · You can select the volume level ("VOLUME 0" (VOL MIN) to "VOLUME 40" (VOL MAX) and "VOLUME ­ ­"). If you select "VOLUME ­ ­, " the volume is set to the last level when the System is turned off. · When the on-time comes, the System sets the volume gradually to the preset level. CD player section Dynamic range: Signal-to-noise ratio: Wow and flutter: 88 dB 85 dB Immeasurable USB storage USB specification: Compatible device: Compatible file system: Bus power supply: Compatible with USB 2. 0 Full Speed Mass storage class FAT16, FAT32 Max. 500 mA Speakers Speaker units: Impedance: Dimensions (approx. ): Mass (approx. ): 10 cm cone x 1 4 160 mm x 250 mm x 150 mm (W/H/D) 1. 6 kg each · To exit from the timer setting, press CLOCK/TIMER as required. You can return to the previous step. General JVC bears no responsibility for any loss of data in USB mass storage class device while using this System. Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Power requirements: AC 230 V , 50 Hz Power supply to USB mass storage class device: 500 mA DC 5 V Power consumption: 20 W (power on) 6. 5 W (standby mode) 1 W or less (Save Mode) Dimensions (W x H x D): 165 mm x 251 mm x 269 mm Mass: 2. 6 kg Specifications and appearance are subject to change without prior notice. Turning Off the System Automatically --AUTO STANDBY function (only for Disc/USB) Press and hold until the A. STBY indicator lights on the display. To cancel this function, press and hold again. To Turn Off the Daily Timer 1 Press repeatedly to select "DAILY 1, " "DAILY 2, " or "DAILY 3. " 2 To turn on the Daily Timer again, select one of the timer settings by pressing CLOCK/TIMER, then press SET. As the number increases, the sound becomes louder. 6 8 Warnings, Cautions and Others CAUTION: (Standby/on) button! [. . . ] \ The path between the remote control and the remote sensor on the System is blocked. If the System does not work correctly, disconnect the AC power cord from the wall outlet, wait for a while, and connect the cord again. 1 Timer Operations Daily Timer does not work. Timer starts working only when the System is turned off. Tuner section FM tuning range: AM tuning range: 87. 50 MHz - 108. 00 MHz 530 kHz - 1 710 kHz (in 10 kHz spacing) 531 kHz - 1 710 kHz (in 9 kHz spacing) 2 2 · If you have already adjusted the clock before, press the button repeatedly until the clock setting mode is selected. or or 1 2 3 4 · To exit from the clock setting, press CLOCK/TIMER as required. [. . . ]