User manual JVC RX-DP20VBK

[. . . ] The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The (STANDBY/ON) switch in any position does not disconnect the mains line. To avoid personal injury or accidentally dropping the unit, have two persons unpack, carry, and install the unit. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. [. . . ] With "ZONE2PREOUT" set to "VARIABLE, " no sounds come out of the ZONE 2 PREOUT jacks if the volume level is set to "­ ­ ­ dB. " In this case, increasing the volume level will enable the sound output through the ZONE 2 PREOUT jacks. 7 SPEAKER 2 When using the FRONT 2/ZONE 2 SPEAKERS terminals, determine the speaker terminal usage: SPEAKER 2 : Select to connect the second front speakers in Zone 1. BI-AMP OUT : Select to connect the front speakers in Zone 1 using bi-amplifier connection*. The BI-AMP indicator (as well as the front speaker 1 indicator) will light up when the front speakers 1 are activated. When you have connected an MD recorder or CD player equipped with the TEXT COMPU LINK remote control system (see page 63), you can show text information, such as disc title or track title, on the display of this receiver. * If your speaker has two pairs of input terminal (one for the high frequency range and the other for the low frequency range), you can connect the speakers by using both the FRONT 1 SPEAKERS and FRONT 2/ZONE 2 SPEAKERS terminals on the rear of this unit. When "BI-AMP OUT" is selected, the surround back speakers are automatically deactivated. In this case, the SURR CH OUT submenu cannot be adjusted (see page 42). Though you have selected "TEXT, " the source name and Surround/THX/DSP mode will appear while playing a disc that has no text information. This unit memorizes many settings separately for each source (see page 28). In addition, you can store the volume level for each source together with the other memorized settings. You can select whether or not to superimpose the menus on the playback pictures on the TV screen. 7 SUPERIMPOSE Turn on or off superimpose: ON : Select to superimpose the menus on the playback pictures on the TV screen. 7 ONE TOUCH OPE Select one of the following to store the volume level for each source: ON : Select to store the volume level setting separately for each source. When you turn on the power, · OFF : Select not to store the volume level setting. If a video component and this unit are connected only using component cords, Superimpose will not work. While Superimpose is in use, the menus may fluctuate or may be distorted depending on the playback pictures. To recall the volume level With the ONE TOUCH OPERATION indicator lit, the volume level for the currently selected source is recalled when the source is selected. Sound adjustment operations are only possible while the receiver is ready for Zone 1 operations. (When one of the other modes is activated, or when the source is "DVD MULTI" or "EXT 7. If Analog Direct is in use (see page 27), you cannot make any sound adjustments using the Adjustment Menu. [. . . ] Speakers are overloaded because of high volume either in Zone 1 or in Zone 2. Speakers are overloaded because of a short circuit of the speaker terminals. The STANDBY lamp goes off after turning on the power, but soon the receiver turns off again (into standby mode). The BAND 1/2 selectors on the rear and on the remote control are set to a different band. [. . . ]