User manual JVC RX-5050B

[. . . ] AUDIO/VIDEO CONTROL RECEIVER RX-5050B/RX-5052S TA/NEWS/INFO DISPLAY MODE INSTRUCTIONS For Customer Use: Enter below the Model No. Serial No. LVT1290-001A [J] Warnings, Cautions and Others/ Mises en garde, précautions et indications diverses CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. S. A This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Ignition noise from automobiles. "OVERLOAD" starts flashing on the display. Speakers are overloaded because of high volume. Speakers are overloaded because of short circuit of speaker terminals. "DSP NG" appears on the display. The built-in microcomputer is not functioning correctly. The receiver is overloaded because of a high voltage. The STANDBY lamp lights up after turning on the power, and soon the receiver turns off again (into standby mode). Remote control does not work. There is an obstruction between the remote sensor on the receiver and the remote control. (See pages 28 to 31. ) Remote control does not work as you intend. An incorrect remote control operation mode is selected. 32 Specifications Amplifier Output Power At Stereo operation Front channels: 100 W per channel, min. RMS, driven into 8 , 40 Hz to 20 kHz with no more than 0. 8% total harmonic distortion. 100 W per channel, min. RMS, driven into 8 , at 1 kHz with no more than 0. 8% total harmonic distortion. RMS, driven into 8 , at 1 kHz with no more than 0. 8% total harmonic distortion. RMS, driven into 8 , at 1 kHz with no more than 0. 8% total harmonic distortion. At Surround operation Front channels: Center channel: Surround channels: Audio Audio Input Sensitivity/Impedance (1 kHz) CD, TAPE/CDR, VCR, TV SOUND, DVD: Audio Input (DIGITAL IN)* Coaxial Optical 220 mV/47 k 0. 5 V(p-p)/75 ­21 dBm to ­15 dBm (660 nm ±30 nm) DIGITAL 1 (DVD): DIGITAL 2 (CD): * Corresponding to Linear PCM, Dolby Digital, and DTS Digital Surround (with sampling frequency--32 kHz, 44. 1 kHz, 48 kHz) Recording Output Level TAPE/CDR, VCR: 220 mV Signal-to-Noise Ratio ('66 IHF/'78 IHF) CD, TAPE/CDR, VCR, TV SOUND, DVD: Frequency Response (8 ) CD, TAPE/CDR, VCR, TV SOUND, DVD: Equalization (5 bands) 63 Hz, 250 Hz, 1 kHz, 4 kHz, 16 kHz: 87 dB/74 dB 20 Hz to 50 kHz (+1 dB, ­3 dB) ±8 dB (in 2 dB steps) Video Video Input Sensitivity/Impedance Composite video Video Output Level Composite video Synchronization: Signal-to-Noise Ratio: DVD, VCR: 1 V(p-p)/75 1 V(p-p)/75 Negative 45 dB VCR, MONITOR OUT: 33 Specifications FM tuner (IHF) Tuning Range: Usable Sensitivity 50 dB Quieting Sensitivity Monaural: Monaural: Stereo: 87. 5 MHz to 108. 0 MHz 12. 8 dBf (1. 2 µV/75 ) 16. 0 dBf (1. 7 µV/75 ) 37. 5 dBf (20. 5 µV/75 ) 35 dB at 1 kHz Stereo Separation at OUT (REC): AM tuner Tuning Range: 530 kHz to 1 710 kHz General Power Requirements: Power Consumption: AC 120V , 60 Hz 200 W/260 VA (at operation) 2 W (in standby mode) 435 mm x 146. 5 mm x 369. 5 mm (17 3/16 in. x 14 5/8 in. ) 7. 5 kg (16. 6 lbs) Dimensions (W x H x D): Mass: Designs and specifications are subject to change without notice. 34 RX-5050B/RX-5052S AUDIO/VIDEO CONTROL RECEIVER EN © 2005 Vicotor Company of Japan, Limited 1204RYMMDWJEIN AUDIO/VIDEO CONTROL RECEIVER RECEPTEUR DE COMMANDE AUDIO/VIDEO RX-5050B/RX-5052S TA/NEWS/INFO DISPLAY MODE INSTRUCTIONS MANUEL D'INSTRUCTIONS LVT1290-002A [C] Français English Warnings, Cautions and Others/ Mises en garde, précautions et indications diverses CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN For U. S. A This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. TO REDUCE THE RISK OF ELECTRIC SHOCK. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. CAUTION To reduce the risk of electrical shocks, fire, etc. : 1. ATTENTION Afin d'éviter tout risque d'électrocution, d'incendie, etc. : 1. Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffret de l'appareil. Ne pas exposer l'appareil à la pluie ni à l'humidité. For Canada/pour le Canada CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND. Caution­­STANDBY/ON button!button in any position does not The STANDBY/ON disconnect the mains line. [. . . ] To resume, press 3. 2 4 MENU Now you can perform the following operations on the VCR: VCR: Turn on and off the VCR. Change the TV channels on the VCR. After pressing VCR, you can perform the following operations on the VCR: 3: REW: FF: 7: 8: REC PAUSE: Start playing. To start recording, press this button then 3. After pressing DVD, these buttons can be used for the DVD menu operations. 6 8 Note: For detailed menu operations, refer to the instructions supplied with the discs or the DVD player. 7/P ENTER 5 Try to operate your VCR by pressing STANDBY/ON VCR. When your VCR turns on or off, you have entered the correct code. If there are more than one code listed for your brand of VCR, try each one until the correct one is entered. 10 5 Try to operate your DVD player by pressing DVD. [. . . ]