User manual JVC RX-430VBX

[. . . ] AUDIO/VIDEO CONTROL RECEIVER AUDIO/VIDEO-RECEIVER MIT STEUEREINHEIT AMPLI/TUNER DE COMMANDE AUDIO/VIDEO GEINTEGREERDE AUDIO/VIDEO-VERSTERKER RECEPTOR DE CONTROL DE AUDIO/VÍDEO RICEVITORE DI CONTROLLO AUDIO/VIDEO RX-430VBK TV /VIDEO /I TV VCR AUDIO CH+ 1 TEST 4 PRESET SEA MODE 2 3 CH­ DELAY SURR MODE 5 6 CD 7/P ­ 8 REAR + 9 TAPE CD-DISC AUDIO CONTROL ­ CENTER 10 +10 + MASTER VOLUME RX-430V AUDIO/VIDEO CONTROL RECEIVER TUNER/BAND PRESET SEA SOURCE SURROUND ADJUST SETTING FM/AM SEA SURROUND ON/OFF ON/OFF VCR TV TV CONTROL ­ + ­ VOLUME + ONE TOUCH OPERATION VIDEO MEMORY ONE TOUCH OPERATION PHONO ­ VOLUME + MUTE RM-SR430EU REMOTE CONTROL STANDBY POWER PHONES 1 SPEAKERS 2 ENHANCED COMPULINK CONTROL SYSTEM _ON --OFF STANDBY/ON _ON --OFF INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING MANUAL DE INSTRUCCIONES ISTRUZIONI For Customer Use: Enter below the Model No. Serial No. LET0022-001A [EF, G] Warnings, Cautions and Others/Warnung, Achtung und sonstige Hinweise/ Mises en garde, précautions et indications diverses/Waarschuwingen, voorzorgen en andere mededelingen/Avisos, precauciones y otras notas/ Avvertenze e precauzioni da osservare IMPORTANT for the U. K. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. [. . . ] Press Control @ / # to set the loudness function to "ON" or "OFF. " · Select "ON" to activate the loudness function. The indicator goes off. Using the Sleep Timer Using the Sleep Timer, you can fall asleep to music and know the receiver will turn off by itself rather than play all night. Press SETTING so that the Control % / fi / @ / # buttons work for setting the Sleep Timer. Press Control % / fi until "<SLEEP>" appears on the display. Each time you press the button, the shut-off time on the display changes as follows, and the SLEEP indicator lights up on the display. 10 20 30 40 50 (Canceled) 60 70 80 0 Page 13 SETTING To check or change the time remaining until the shut-off time: 1. Press SETTING if necessary, so that the Control % / fi / @ / # buttons work for setting the Sleep Timer. Press Control % / fi if necessary, until "<SLEEP>" appears on the display. To cancel the Sleep Timer, press Control @ / # repeatedly in step 3 above until "0" appears on the display. (The SLEEP indicator goes off. ) Turning off the power (into standby mode) also cancels the Sleep Timer. Selecting the Center Speaker Size You can register the information about the center speaker after all connections are completed. If you do this registration first, you do not have to adjust the center speaker mode when you want to activate the surround sound. However, to register the information, first you have to set the surround mode either to "PROLOGIC" or "3CHLOGIC. " (You cannot select the center speaker size when the surround mode is "OFF" or "HALL. ") On the front panel only: SURROUND 1. Press SURROUND so that the Control % / fi buttons work for selecting the surround mode. Press Control % / fi until "PROLOGIC" or "3CHLOGIC" appears on the display. Press SETTING so that the Control % / fi / @ / # buttons work for selecting the center speaker size. Press Control % / fi until "CNTR SPK" (Center Speaker) appears on the display. Press Control @ / # to select the appropriate item about your center speaker. Each time you press the button, the display changes to show the following: LARGE SMALL NO LARGE Select this mode when the size of the center speaker is the same as that of the front speakers. SMALL Select this mode when the size of the center speaker is smaller than that of the front speakers. (This mode cannot be selected when you select "3CHLOGIC. ") Note: This "center speaker size" setting is so related to the center mode setting for the Dolby Surround that changing this setting affects and changes the center mode to a relevant mode, and vice versa. For example; · If you select "LARGE, " the center mode is automatically set to "WIDE, " and vice versa. · If you select "SMALL, " the center mode is automatically set to "NORMAL, " and vice versa. · If you select "NO, " the center mode is automatically set to "PHANTOM" for PRO LOGIC, and vice versa. Page 14 English When the shut-off time comes, the receiver turns off (into standby mode) automatically. English One Touch Operation This receiver can memorize the optimum sound setting for each playing source. About the One Touch Operation JVC's One Touch Operation function is used to assign and store different sound settings for each different playing source. [. . . ] Note: If you do not press the record (¶) button and pause (8) button at the same time, the synchronized recording feature will not operate. The source changes on the receiver, and as soon as play starts, the cassette deck starts recording. When the play ends, the cassette deck enters recording pause, and stops 4 seconds later. Notes: · During synchronized recording, the selected source cannot be changed. [. . . ]