User manual JVC RC-ST3SL

[. . . ] ­ If water or some liquid gets inside the unit, unplug the power cord from the outlet and consult your dealer. Avoid installing the unit in the following places: ­ Where the temperature may become excessively high or low; the recommended temperature range is between 5°C and 35°C. Do not use the unit in direct sunlight or leave it in a closed automobile, etc. Ventilation Do not block the ventilation holes of the unit; otherwise heat cannot escape from the unit. [. . . ] When the unit is turned off In step 1, you can press the PROGRAM button only on the main unit, not on the remote control unit. If the unit is disconnected from the power source for a certain period of time, the clock setting will be lost. 1 Press and hold PROGRAM on the main unit until the hour indication starts flashing. The unit has several preset EQ (equalizer) settings so that you can select one that most matches the type of music being played. Each time you press the button, the EQ setting changes as shown below. Do not turn off the unit with the volume set to an extremely high level; otherwise a sudden blast of sound might be produced damaging your hearing and/or the speakers, when you turn on the unit next time or start playing another source. You can enjoy powerful bass sound by turning on the Hyper-Bass Sound effect. When the Hyper-Bass Sound effect is turned on, the HBS indicator lights up in the display window. Turn down the volume before connecting headphones and keep the volume level low; as listening at high volumes could damage your hearing. The following care should be taken to keep discs in good condition, since dirty, damaged or warped discs could lead to sound deterioration and damage the unit. Do not expose discs to direct sunlight, high temperatures from a heater, etc. To remove a disc from its storage case, press the center and lift the disc out. The unit can also play CD-R and CD-RW discs recorded in music CD format. User-edited CD-R (Recordable) and CD-RW (Rewritable) discs can be played only if they are already finalized. Some CD-R and CD-RW discs may not be played on the unit depending on the disc characteristics or recording conditions. Before playing CD-R or CD-RW discs, read their instructions and cautions carefully. Some CD-R and CD-RW discs may not be played on the unit because of damage or stain on them, or if the CD pickup lens is dirty. CD-RW discs may require a longer readout time (due to the fact that the reflectance of CD-RW discs is lower than that of regular CDs). When replacing a disc in its case, press the center part to secure the disc. Clean off any dust, dirt or fingerprints on discs with a soft, dry cloth, wiping from the center to edge. 3 Press 3/8 PLAY/PAUSE (or CD 3/8 on the remote control unit) to start playback. During playback, the current track number and the elapsed playing time of the track are displayed. [. . . ] 2 Press 8 PAUSE again to release the tape at the exact moment you want to start recording. You can specify a desired track to start recording by pressing 4 or ¢. You can erase the recording on a tape without overwriting the tape with a new recording. How to reset the unit If normal operations are disabled, reset the unit as follows: 1. [. . . ]