User manual JVC RC-EX30B

[. . . ] There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. CD functions can be operated with the remote control unit as well as on the main unit. Even when the STANDBY/ON button is set to STANDBY, a very small current will flow. [. . . ] (Note, however, that the display window does not light even when the unit is turned on if the unit is operated on batteries. ) The unit comes on ready to play the source selected when the unit was last turned off. When you unplug the AC power cord or if a power failure occurs, the clock is reset to "0:00" right away, while the tuner preset stations (see page 15) will be erased in a few days. The clock indication will keep flashing until you set the clock again. Remove the batteries when carrying the unit by hand or in the trunk of a car. This prevents the power from being accidentally turned on, thus avoiding wasteful battery consumption. To switch off the power supply completely Unplug the AC power cord from the AC outlet. Before operating the unit any further, first set the clock built in this unit. Note: If there is a power failure, the clock loses the setting and is reset to "0:00. " The clock indication will keep flashing until you set the clock again. Each time you press the button, the display changes the clock indication and the normal indication alternately. If you press CD/RANDOM while in CD mode, the unit enters the random playback mode. To skip back to the previous track During playback, press 4 once to return to the beginning of the current track, press twice to skip back to the beginning of the previous track. To skip to the next track During playback, press ¢ to skip to the beginning of the next track. Monitor the sound and release the button when the desired position is located. Main unit Main unit Remote You can press CD REPEAT / PRESET + on the remote control unit to select repeat playback. Each time you press the button, the repeat mode changes in the following order: Repeat playback of all tracks on the disc ("REPEAT ALL" lights up. You can press CD/RANDOM on the remote control unit to select random playback. To cancel random playback, press the button again so that the RANDOM indicator goes off. If the setting is canceled before you finish, start from step 2 again. The PROG indicator goes off and the unit exits from programmed playback. Each time you press the button, the programmed tracks are shown in the display window. [. . . ] You can make the CD player to start playback when the tape deck enters the recording mode. To start recording from the desired track, select the track by pressing 4 or ¢ in stop mode. To start recording from the desired point on a disc, play the disc and pause at the desired point by pressing PLAY/PAUSE 3/8 (or CD PLAY/PAUSE on the remote control unit). When the tape reaches the end first, the CD player enters the pause mode. [. . . ]