User manual JVC RC-EX25SE

[. . . ] The STANDBY/ON button in any position does not disconnect the mains line. ) · Do not place any naked flame sources, such as lighted candles, on the apparatus. When discarding batteries, environmental problems must be considered and local rules or laws governing the disposal of these batteries must be followed strictly. Do not expose this apparatus to rain, moisture, drippimg or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. [. . . ] (Operating the unit while clock indication is displayed changes the display to the normal indication. You can press VOLUME + or VOLUME ­ on the remote control unit to increase or decrease the volume respectively. press and hold HBS/PRESET EQ so that the HBS indicator lights up in the display window. To turn off the effect, press and hold the button again so that the HBS indicator goes off. Caution: DO NOT turn off the unit with the volume set to an extremely high level; otherwise a sudden blast of sound could damage your hearing and/or the speakers and headphones, when you turn on the unit or start playing another source next time. Press HBS/PRESET EQ repeatedly until the indicator for the sound mode you want appears in the display window. Each time you press the button, the sound mode changes as follows: Turning off the sound temporarily during playback , press MUTING. The sound is turned off and the MUTING indicator appears in the display window. You can play back finalized CD-R or CD-RW recorded in music CD format. (If a CD-RW has been recorded in a different format, erase all the data on the CD-RW completely before recording on it. Some CD-R or CD-RW may not be played back on this unit because of their disc characteristics, damage or stain on them, or if the player lens is dirty. The reflection factor of CD-RW is lower than that of other CDs, possibly causing CD-RW to take longer time to read. Since dirty, damaged or warped discs could damage the unit, care should be taken of the following: · Do not stick or write anything on the label side. After removing a disc from the unit, be sure to put it back in its case. Do not expose discs to direct sunlight, high temperatures from a heater, etc. Before loading a disc, wipe off any dust, dirt or fingerprints with a soft, dry cloth. 1 Press CD/RANDOM to enter CD mode, if the unit is in TUNER or TAPE mode. The current track number and elapsed playing time are displayed during playback. Check that the disc has completely stopped rotating before unloading the disc. The following indication may be displayed when the disc is loaded upside down. You can press CD PLAY/PAUSE on the remote control unit to pause playback. Mistracking may occur if a strong shock is applied to the unit or if it is used in a place subject to vibrations (e. [. . . ] press PLAY/PAUSE 3/8 (or CD PLAY/PAUSE on the remote control unit) to continue playback , or press STOP 7 (or STOP on the remote control unit) to stop playback. When recording on a pre-recorded tape, the previous recording is erased and only the new recording is heard next time the tape is played back. To erase a tape without making a new recording 1 Press TAPE on the unit to enter the tape mode. When the tape is running, magnetic powder and dust naturally accumulate on the heads, capstan and pinch roller. [. . . ]