User manual JVC KW-XC777 Instruction Manual

[. . . ] CD/CASSETTE RECEIVER ''/" KW-XC777 EX For installation and connections, refer to the separate manual. հ"`--߷"TMա , "`ߧY'˷" INSTRUCTIONS Yհ", , TM" LVT0834-001A [U] ". . . " ENGLISH ENGLISH 2 IMPORTANT FOR LASER PRODUCTS Precautions: 1. CLASS 1 LASER PRODUCT 2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. 4. CAUTION: This CD player uses invisible laser radiation, however, is equipped with safety switches to prevent radiation emission when unloading CDs. 5. CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. About the demonstration mode (DEMO MODE). . . When shipped from the factory, "DEMO" is set to "DEMO ON" in this unit. The demonstration will start automatically if no sound comes in for 3 minutes. [. . . ] When shipped from the factory, the clock is set not to be shown on the display. CLOCK ON: Clock display is turned on. Selecting the external component to use EXT INPUT You can connect the external component to the CD changer jack on the rear using the Line Input Adaptor KS-U57 (not supplied). To use the external component as the playback source through this unit, you need to select which component CD changer or external component to use. When shipped from the factory, CD changer is selected as the external component. LINE INPUT: To use the external component other than CD changer. Note: If the power supply is not interrupted by turning off the ignition key of your car, it is recommended to select "CLOCK OFF" to save the car's battery. Selecting the dimmer mode DIMMER When you turn on the car headlights, the display automatically dims (Auto Dimmer). DIM AUTO: Activates Auto Dimmer. Notes: If the current source is CD changer or external component, this item does not appear. For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/ Connection Manual (separate volume). Note: Auto Dimmer equipped for this unit may not work correctly on some vehicles, particularly on those having a control dial for dimming. In this case, set the dimmer mode to "DIM ON" or "DIM OFF. " Adjusting the auxiliary input level AUX ADJ Adjust the auxiliary input level properly when an external component is connected to the auxiliary input jack. When shipped from the factory, the auxiliary (AUX) input level is set at level 00. If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change the source from the external component to another source. Adjusting the display contrast level CONTRAST You can adjust the display contrast level among 1 (dark) to 10 (bright). When shipped from the factory, the display contrast level is set at level 5. Selecting the scroll mode SCROLL You can select the scroll mode for the disc information. When shipped from the factory, Auto Scroll mode is set to "SCRL ONCE. " SCRL ONCE: Scrolls only once. SCRL OFF: Cancels Auto Scroll. 24 You can turn the demo mode on or off. The demonstration will start automatically if no sound comes in for 3 minutes. You can assign names to station frequencies and the external component connected to the AUX input jack. After assigning a name, it will appear on the display when you select the source. Sources Station frequencies* Maximum number of the characters Up to 10 characters (up to 32 station frequencies including both FM and AM) Up to 10 characters Note: If the unit has been reset (and the power is on), demonstration will start if no sound comes in for about 15 seconds. External components ("AUX INPUT" only) * You cannot assign name to a station frequency stored in the EX (extra) button. 1 Select a source you want to assign a name to. When you select a source, the power automatically comes on. Each time you press the button, the source changes as described on page 7. 2 Press and hold SEL (select) for more than 2 seconds while pressing DISP (display). (at the same time) CONTINUED TO THE NEXT PAGE 25 ENGLISH Turning the demo mode on or off DEMO MODE Assigning names to the sources ENGLISH 3 Select the character set you want while " " is flashing. Each time you press the button, the character set changes as follows: To erase the input characters Press and hold DISP (display) for more than 1 seconds to erase all the characters at a time. Capital letters ( ) Note: When you try to assign a name to the 33rd station frequency, "NAME FULL" appears on the display. (In this case, delete unwanted names before assignment. ) Small letters ( ) ) Available characters Capital letters A F K P U Z B G L Q V space Numbers and symbols ( C H M R W D I N S X E J O T Y 4 Select a character. About the available characters, see the right column. Small letters 5 Move the cursor to the next (or previous) character position. a f k p u z b g l q v space c h m r w d i n s x e j o t y 6 7 Repeat steps 3 to 5 until you finish inputting the name. Finish the procedure while the last selected character is flashing. Number and symbols 0 5 != ` % * / > space & + : ? 26 EXTERNAL COMPONENT OPERATIONS ENGLISH MD player, etc. EX You can connect two external components to this unit. Connect one to the auxiliary (AUX) input jack on the control panel, and the other to the CD changer jack on the rear. 2 3 Turn on the connected component and start playing the source. Adjust the volume. Preparations: For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/ Connection Manual (separate volume). Before operating the external component connected to the CD changer jack, select the external input correctly. [. . . ] ˫ wzuNë UZUL ë . . . --UO ë W--UD l WOzUdNJë wUë q K ë V S bl ʫ wJOUu . . . --UO qJO lĮ -- l oeu pK ë 1 XU?L . . . --UO?ë 2 Xu w U{ dDë l dLS pK ë 3 iOU jD , --" pK 4 ds "UNl vë bF sZ rJײë ds wJOUu WUDë wzu vë , --" 5 dOī wKO s d« WU VKD W?UDë w?zu VK?D U?bMZ U?C q?LF??ë 6 . . . dOGBë WLKë ˫ . . . U{ UZUL ë l ds , , 7 wzuNë pK q ˫ "UN' l , , qUS q ˫ dOs 2 3 2 3 XUuL "UNl ˫ JVC W--U CD W-b WuDݫ b ds wl--Us L R F-OUT R-OUT L L R R CH-X WK K sCD W-b* WuD b bS qO u w u CD W-b* WuD b qO u bMZ ƩKS-U15K w U{ pK vë U% u KD-MK WK K s tJK9 cë CD W-b* WuD b U j) qsoe vUN qO u WDݫu qIM MD p oe wMO qGA q wl--Us XUuL "UNl qO u UC pMJ1 B rdë dE Ʃoe e dOz KS-U57 2 . . . --UO ë wzu vë wHK) i--Që d dOī "uO 1 "UN' c l o d dOz WuD b fI JVC W--U CD W-b 3 oeu * * qOGAë UH 1 wbF* . . . --UO ë qJO ˫ wbF* r ' vë L R dH 2 W--UDë l Wu u* "uOHë WZuL- w w( dDë vë ƩUF UH0 --dĮ "UN' c l oee dOz . . . --U pK B rdë dE ds "UNl vë dLS 3 "uOHë WZuL- w w U{ dDë vë "uOHë , , uK iOU jD , --" pK 4 B rdë dE ds "UNl vë 6 V?-? b "UN' qOGA sJ?1 YOS pK ë c qO u pK ë qO u , --" 5 wJOUu wzuNë vë iOU jD wUId pK . . . dOGBë WLKë ˫ . . . U{ d vë 7 jD iOЫ pK oeuU iO oeuU jD oeU-- oeU-- oeuU jD dCs dCs oeuU jD vul-- vul-- d Oë WZUL ë WOU vMLOë WZUL ë WOU d Oë WZUL ë WOHK) vMLOë WZUL WOHK) U O Yu . . . --UO q oe "UN' "UN' VOd bM U O Yu . . . --UO l WKLF * WOHBë rdë w sO u UL . . . oee* WOHBë XL 3 PRECAUTIONS on power supply and speaker connections: DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. [. . . ]