User manual JVC KW-NT700

[. . . ] ­ This warning appears only when the parking brake lead is connected to the parking brake system built in the car. It is recommended to connect speakers with a maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change "Amplifier Gain" setting to prevent the speakers from being damaged (see page 112 of the INSTRUCTIONS). To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape. [. . . ] Flat head screws*1 (M5 x 8 mm) Flachkopfschrauben*1 (M5 x 8 mm) Vis à tête plate*1 (M5 x 8 mm) Round head screws*1 (M2. Use these screws when installing the unit without the supplied sleeve. However, you should make adjustments corresponding to your specific car. If you have any questions or require information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits. If you are not sure how to install this unit correctly, have it installed by a qualified technician. Before installing the unit When mounting the unit, be sure to use the screws provided, as instructed. When tightening screws or bolts, be careful not to pinch any connection cord. Make sure not to block the fan on the rear to maintain proper ventilation when installing the unit. Be sure to keep all the screws and parts removed from your car for future use. Install the unit at an angle of less than 30° vertically and of less than 5° horizontally. ) To car light control switch Zum Autobeleuchtungssteuerung-Schalter À l'interrupteur d'éclairage de la voiture To cellular phone system Zur Mobiltelefon À un système de téléphone cellulaire To parking brake (see diagram Å below. White with black stripe Weiß mit schwarzem Streifen Blanc avec bande noire White Weiß Blanc Gray with black stripe Grau mit schwarzem Streifen Gris avec bande noire Gray Grau Gris Green with black stripe Grün mit schwarzem Streifen Vert avec bande noire Green Purple with black stripe Lila mit schwarzem Grün Streifen Vert Violet avec bande noire Left speaker (rear) Linker Lautsprecher (hinten) Enceinte gauche (arrière) Purple Lila Violet Right speaker (rear) Rechter Lautsprecher (hinten) Enceinte droit (arrière) Connect the parking brake lead to the parking brake system built in the car. Connecting the speed signal lead / Anschließen der Geschwindigkeitssignalleitung / Connexion du fil de signal de vitesse This connection is necessary to use the Navigation System. You can supply the power to the amplifiers by connecting the remote leads (blue with white stripe) of this unit and amplifiers. (To connect more than one amplifier using the remote leads, Yconnectors need to be separately purchased. ) · Disconnect the speakers from the unit, and connect them to the amplifier. You can switch off the built-in amplifier and send the audio signals only to the external amplifier(s) to get clear sounds and to prevent internal heat built-up inside the unit. Guidance voice comes out only through the front speakers (and the front line out on the rear). *4 Firmly attach the ground lead to the metallic body or to the chassis of the car--to the place uncoated with paint (if coated with paint, remove the paint before attaching the lead). *5 If your car is equipped with the steering wheel remote controller, you can operate this unit using the controller. [. . . ] *5 If your car is equipped with the steering wheel remote controller, you can operate this unit using the controller. To do it, a JVC's OE remote adapter (not supplied) which matches with your car is required. Before connecting the external components, make sure that the unit is turned off. You can also connect the following components through the various JVC adapters. [. . . ]