User manual JVC KV-MR9010

[. . . ] Be sure not to let the monitor fall or be strongly impacted since this may cause a malfunction or fire. Doing so with the engine off will consume battery power and may prevent the engine from starting. When not in use, close the liquid crystal panel and store it into the compartment. [. . . ] ­ Bewaar de batterij niet met andere metalen ­ Die Batterie nicht zusammen mit ­ Ne laissez pas la pile avec d'autres ­ Do not leave the battery with other materialen. ­ Steek niet met een tangetje of dergelijk ­ Die Batterie nicht mit Pinzetten oder ­ Ne piquez pas la pile avec des ciseaux ­ Do not poke the battery with tweezers gereedschap in de batterij. ­ Wikkel de batterij met band om en isoleer ­ Die Batterie mit Klebeband umwickeln ­ Enveloppez la pile de ruban isolant ­ Wrap the battery with tape and insulate goed alvorens weg te gooien of langdurig und isolieren, wenn sie entsorgt oder avant de la mettre au rebut ou de la when throwing away or saving it. Do not expose the remote sensor to strong light (direct sunlight or artificial lighting). Controllable only if your car receiver which is connected to this monitor is one of the JVC receivers. Before operating the unit, make sure that all external components are correctly connected and installed. When not in use, close the liquid crystal panel and store it into the compartment; however, it may obstruct the visibility through the rearview mirror. Press PUSH-OPEN until the liquid crystal panel is unlocked, then open the liquid crystal panel by both hands. When closing the liquid crystal panel, store it in the screen compartment until it is locked. 1 Slide the arm lock lever to RELEASE, then pull down or push up the monitor. 2 Slide the arm lock lever to HOLD, then remove the screen arm to the nearest locking position. When closing the liquid crystal panel, push up the monitor to the highest position. To turn off the power / So prüfen Sie die aktuelle Eingangsquelle / Pour mettre l'appareil hors tension / Uitschakelen van de stroom OFF: Activates the door sensor which turns on the dome lights when a · You can use JVC's optional cordless headphones KS-HP2 to listen to the playback sounds of the external component. Playback sounds are transmitted through IR transmitters to the cordless headphones. Menu selection goes off if other operations are done or no operation is done for about 5 seconds. Initial level: 0 (center) Control the degree of difference between the lightest and darkest parts of the picture. Initial level: 0 (center) Adjust this if the human skin color is unnatural. Initial level: 0 (center) Set to "ON" when you listen to the playback sounds using JVC's optional cordless headphones KS-HP2. [. . . ] ­ Do not leave the unit in contact with rubber or vinyl products for long periods of time. ­ Do not use cleansers which have polishing granules because this could damage the cabinet. Clean off dirt by wiping lightly with a soft cloth When the cabinet is very dirty, wipe with a well-wrung cloth dipped in a kitchen cleanser (neutral) thinned by water and then go over the same surface with a dry cloth. [. . . ]