User manual JVC KD-SD631

[. . . ] ENGLISH FRANÇAIS KD-SD631 CD RECEIVER / RÉCEPTEUR CD For canceling the display demonstration, see page 4. / Pour annuler la démonstration des affichages , référez-vous à la page 4. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. [. . . ] Bluetoothா For Bluetooth operations, it is required to connect the Bluetooth adapter, KS-BTA100 (separately purchased) to the auxiliary input jack (R-AUX/BT ADAPTER) on the rear of the unit. ( Installation/Connection Manual) KS-BTA100 is not available in some countries. Operations may be different depending on the connected Bluetooth device. KS-BTA100 Preparation For details on registering and using the Bluetooth device, refer to the instructions manual supplied with KS-BTA100. All zone Selecting the preset color You can select a preset color for <BUTTON ZONE>, <DISP ZONE>, and <ALL ZONE> separately. Storing your own adjustments You can store your own day and night colors for <BUTTON ZONE> and <DISP ZONE> separately. 3 3 BUTTON ZONE DAY COLOR DISP ZONE BUTTON ZONE NIGHT COLOR DISP ZONE ON MENU COLOR OFF Select a primary color <RED/GREEN/ BLUE>, and then adjust the level <00-31>. Repeat this procedure until you have adjusted all the three primary colors. If “00” is selected for all the primary colors for <DISP ZONE>, nothing appears on the display. Changes the display and buttons illumination during menu, list search, and playback mode operations. BUTTON ZONE DISP ZONE ALL ZONE COLOR 01-29/USER/ COLOR FLOW 01-03* * Color changes in different speeds. If <ALL ZONE> is selected, the button and display illumination will change to the current/ selected <BUTTON ZONE> color. NIGHT COLOR/DAY COLOR is changed by turning on/off your car’s headlight. Some characters or symbols will not be shown correctly (or will be blanked) on the display. If you are using a two-speaker system, set the fader level to “00”. W LEVEL *7 (Subwoofer level) HPF *7 (High-pass filter) BEEP (Keytouch tone) TEL MUTING *8 (Telephone muting) AMP GAIN *9 (Amplifier gain) SSM AF-REG *10 NEWS-STBY *10 (News standby) P-SEARCH *10 (Programme search) MONO (Monaural mode) Selectable setting (Initial: [XX]) -05 — +05 [00]: Presets the volume adjustment level of each source, compared to the FM volume level. ) Select if the REAR/SW terminals are used for connecting the speakers or subwoofer (through an external amplifier). LOW 55Hz/MID 85Hz/[HIGH 120Hz]: Audio signals with frequencies lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer. ON: Mutes the sounds while using the cellular phone (not connected through KS-BTA100). LOW POWER: VOLUME 00 — VOLUME 30 (Select if the maximum power of each speaker is less than 50 W to prevent damaging the speakers. ) ( page 7) SEARCH ON/[SEARCH OFF]: Activates Programme Search (if <AF-REG> is set to <AF ON> or <AF-REG ON>) or deactivates. This setting does not work if <BT ADAPTER> is selected for <R-AUX> of <SRC SELECT>. [. . . ] Please note that the use of this accessory with iPod, or iPhone may affect wireless performance. Cautions Do not pull out and attach the USB device repeatedly while “READING” is shown on the display. Electrostatic shock at connecting a USB device may cause abnormal playback of the device. In this case, disconnect the USB device then reset this unit and the USB device. [. . . ]