User manual JVC KD-SC402 INSTALLATION

[. . . ] This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC IN-CAR ENTERTAINMENT dealers. To prevent short circuits, we recommend that you disconnect the battery's negative terminal and make all electrical connections before installing the unit. [. . . ] If you are not sure how to install this unit correctly, have it installed by a qualified technician. Insert the two handles, then pull them as illustrated so that the unit can be removed. When using the optional stay / Lors de l'utilisation du hauban en option Stay (option) When installing the unit without using the sleeve / Lors de l'installation de l'appareil scans utiliser de manchon In a Toyota car for example, first remove the car radio and install the unit in its place. *1 When you stand the unit, be careful not to damage the fuse on the rear. : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. * Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?If your car is equipped with the ISO connector / Si votre voiture est équippée d'un connecteur ISO You may need to modify the wiring of the supplied power cord as illustrated. From the car body De la carrosserie de la voiture ISO connector Connecteur ISO Use modified wiring 2 if the unit does not turn on. View from the lead side Vue à partir du côté des fils Incorrect connection may cause serious damage to this unit. The leads of the power cord and those of the connector from the car body may be different in color. Connect the colored leads of the power cord in the order specified in the illustration below. To steering wheel remote controller (see diagram ) Pour la télécommande de volant (voir le diagramme ) To external components (see diagram ) Aux appareils extérieurs (voir le diagramme Rear ground terminal Borne arrière de masse 15 A fuse Fusible 15 A Aerial terminal Borne de l'antenne Line out (see diagram Sortie de ligne (voir le diagramme ) ) To the remote lead of other equipment or power aerial if any (200 mA max. *2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power Cannot be turned on. Connectez le fil de commande à distance (bleu avec bande blanche) au fil de commande à distance de l'autre appareil de façon qu'il puisse être commandé via cet appareil. [. . . ] You can also connect an external component through this unit using Line Input Adapter, KS-U57 (not supplied) or AUX Input Adapter, KS-U58 (not supplied). *3 Firmly attach the ground wire to the metallic body or to the chassis of the car--to the place uncoated with paint *4 *5 *6 *7 (if coated with paint, remove the paint before attaching the wire). Signal cord (not supplied for this unit) Cut the rear speaker leads of the car's ISO connector and connect them to the amplifier. [. . . ]