User manual JVC KD-S1501EU

[. . . ] To turn off the power You cannot select "CD" as the playback source if there is no disc in the loading slot. Lower the volume before playing a disc to avoid damaging the speakers by the sudden increase of the output level. If no operations are done for about 20 seconds, display demonstration starts. To check the current clock time when the power is turned off Lights up when receiving an FM stereo broadcast with sufficient signal strength. [. . . ] You can tune in to a station broadcasting your favorite programme by searching for a PTY code. If there is a station broadcasting a programme of the same PTY code as you have selected, that station is tuned in. What you can do with RDS rDS (Radio Data System) allows FM stations to send an additional signal along with their regular programme signals. By receiving the RDS data, this receiver can do the following: · Other PTY codes into other preset numbers. TA Standby Reception allows the receiver to switch temporarily to Traffic Announcement (TA) from any source other than AM. 2 Select the preset number (1 ­ 6) you (This occurs when you are listening to an FM station without the RDS signals required for TA Standby Reception. ) To activate TA Standby Reception, tune in to another station providing these signals. PTY Standby Reception allows the receiver to switch temporarily to your favorite PTY programme from any source other than AM. To activate PTY Standby Reception, tune in to another station providing these signals. When driving in an area where FM reception is not sufficient enough, this receiver automatically tunes in to another FM RDS station of the same network, possibly broadcasting the same programme with stronger signals (see the illustration below). When shipped from the factory, NetworkTracking Reception is activated. When removing a disc from Center holder its case, press down the center holder of the case and lift the disc out, holding it by the edges. When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up). Do not use the following discs: More about this receiver Turning off the power ⷠIf you turn off the power while listening to a disc, disc play will start from where playback has been stopped previously, next time you turn on the power. This receiver can play back multi-session discs; however, unclosed sessions will be skipped while playing. ⷠSome CD-Rs or CD-RWs may not play back on this receiver because of their disc characteristics, and for the following causes: ­ Discs are dirty or scratched. ­ CD-R or CD-RW on which the files are written with "Packet Write" method. CD-RWs may require a longer readout time since the reflectance of CD-RWs is lower than that of regular CDs. ⷠDo not use the following CD-Rs or CD-RWs: ­ Discs with stickers, labels, or protective seal stuck to the surface. ­ Discs on which labels can be directly printed by an ink jet printer. Using these discs under high temperatures or high humidities may cause malfunctions or damages to discs. ­ All previously stored stations are erased and stations are stored newly. [. . . ] When storing a station manually, a previously preset station is erased when a new station is stored in the same preset number. Network-Tracking Reception requires two types of RDS signals--PI (Programme Identification) and AF (Alternative Frequency) to work correctly. Without receiving these data correctly, NetworkTracking Reception will not operate. ⷠIf a Traffic Announcement is received, the volume level (TA Volume) automatically changes to the preset level. [. . . ]