User manual JVC KD-GS616R SERVICE MANUAL

[. . . ] To use these buttons for their original functions again after pressing MODE, wait for 5 seconds without pressing any of these buttons until the functions mode is cleared or press MODE again. Note: Only for [EX] model users in UK and European countries For security reasons, a numbered ID card is provided with this unit, and the same ID number is imprinted on the unit's chassis. Keep the card in a safe place, as it will help the authorities to identify your unit if stolen. How to read this manual ⷠButton operations are mainly explained with the illustrations in the table below. [. . . ] All tracks of the current folder, then tracks of the next folder and so on. You can select a preset sound mode suitable to the music genre (C-EQ: custom equalizer). LOUD*1 (loudness), [LOUD ON or LOUD OFF] Boost low and high frequencies to produce a well-balanced sound at low volume level. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including "USER. " *2 If you are using a two-speaker system, set the fader level to "00. DEMO DEMO ON : [Initial]; Display demonstration will be activated Display demonstration automatically if no operation is done for about 20 seconds, [7]. When the received signals from the current FM RDS station become weak. AF : [Initial]; Switches to another station (the programme may differ from the one currently received), [11]. : Using the AF data, the unit tunes in to another frequency broadcasting the same programme as the original preset RDS station is if the preset station signals are not sufficient. You can adjust the volume level (VOL ­12 -- VOL +12) of DAB tuner to match the FM sound level and store it in memory. MUTING 1/MUTING 2 : Select either one which mutes the sounds while using a cellular phone. More about this unit basic operations Turning on the power ⷠBy pressing SRC on the unit, you can also turn on the power. Turning off the power If the selected primary service has some secondary services, pressing the same button again will tune in to the secondary services. ⷠIf you turn off the power while listening to a disc, disc play will start from where playback has been stopped previously, next time you turn on the power. You can keep listening to the same programme by activating the Alternative Frequency Reception. ⷠWhile receiving a DAB service: When driving in an area where a service cannot be received, this unit automatically tunes in to another ensemble or FM RDS station, broadcasting the same programme. ⷠWhile receiving an FM RDS station: When driving in an area where a DAB service is broadcasting the same programme as the FM RDS station is broadcasting, this unit automatically tunes in to the DAB service. ­ All previously stored stations are erased and stations are stored newly. When storing a station manually, the previously preset station is erased when a new station is stored in the same preset number. Network-Tracking Reception requires two types of RDS signals--PI (Programme Identification) and AF (Alternative Frequency) to work correctly. Without receiving these data correctly, NetworkTracking Reception will not operate correctly. ⷠIf a Traffic Announcement is received by TA Standby Reception, the volume level automatically changes to the preset level (TA VOL) if the current level is lower than the preset level. [. . . ] ­ Depends on the condition of communication between the iPod or D. Moisture may condense on the lens inside the CD player in the following cases: · If it becomes very humid inside the car. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates. When removing a disc from Center holder its case, press down the center holder of the case and lift the disc out, holding it by the edges. [. . . ]