User manual JVC KD-G425

[. . . ] This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] This unit can show the names of albums, artists (performer), and Tag (Version 1. This unit can play back MP3/WMA files meeting the conditions below: ­ Bit rate: 8 kbps -- 320 kbps ­ Sampling frequency: 48 kHz, 44. The maximum number of characters for file/ folder names vary among the disc format used (includes 4 extension characters--<. files recorded in VBR have a discrepancy in elapsed time display , and do not show the actual elapsed time. Especially, after performing the search function, this difference becomes noticeable. This unit can recognize a total of 512 files, of 200 folders, and of 8 hierarchies. This unit cannot play back the following files: ­ MP3 files encoded with MP3i and MP3 PRO format. ­ WMA files encoded with lossless, professional, and voice format. If you change the source, playback also stops (without ejecting the disc). Next time you select "DISC" for the playback source, disc play starts from where it has been stopped previously. If the ejected disc is not removed within 15 seconds, the disc is automatically inserted again into the loading slot to protect it from dust. If you change the "AMP GAIN" setting from "HIGH PWR" to "LOW PWR" while the volume level is set higher than "VOL 30, " the unit automatically changes the volume level to "VOL 30. Player, some operations may not be performed correctly or as intended. In this case, visit the following JVC web site: For iPod users: <http://www. Finalize the CD-R/CD-RW with the component which you used for recording. Use a disc with MP3/WMA tracks recorded in the format compliant with ISO 9660 Level 1, Level 2, Romeo, or Joliet. A longer readout time is required ("CHECK" keeps flashing on the display). Tracks do not play back in the order you have intended them to play. This unit can only display letters (upper case), numbers, and a limited number of symbols. Player's controls do not work after disconnecting from this unit. Maximum Power Output: Front: 50 W per channel Rear: 50 W per channel Continuous Power Output (RMS): Front: 19 W per channel into 4 , 40 Hz to 20 000 Hz at no more than 0. Type: Compact disc player Signal Detection System: Non-contact optical pickup (semiconductor laser) Number of Channels: 2 channels (stereo) Frequency Response: 5 Hz to 20 000 Hz Dynamic Range: 96 dB Signal-to-Noise Ratio: 98 dB Wow and Flutter: Less than measurable limit MP3 Decoding Format: MPEG1/2 Audio Layer 3 Max. [. . . ] It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 16 of the INSTRUCTIONS). To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. [. . . ]