User manual JVC KD-G161

[. . . ] Do not raise the volume level too much, as this will block outside sounds, making driving dangerous. To use these buttons for their original functions again after pressing M MODE, wait for 5 seconds without pressing any of these buttons until the functions mode is cleared or press M MODE again. If you have parked the car for a long time in hot or cold weather, wait until the temperature in the car becomes normal before operating the unit. * You cannot select "DISC" as the playback source if there is no disc in the unit. [. . . ] To stop play and eject the disc To fast-forward or reverse the track You can select a preset sound mode suitable to the music genre (C-EQ: custom equalizer). LOUD*1 (loudness), [LOUD ON or LOUD OFF] Boost low and high frequencies to produce a well-balanced sound at low volume level. *1 When you adjust the bass, treble, or loudness, the adjustment you have made is stored for the currently selected sound mode (C-EQ) including "USER. " *2 If you are using a two-speaker system, set the fader level to "00. DEMO ON : [Initial]; Display demonstration will be activated automatically if no operation is done for about 20 seconds, [5]. When the received signals from the current FM RDS station become AF-REG weak. Alternative frequency/ : [Initial]; Switches to another station (the programme regionalization reception AF may differ from the one currently received), [9]. : Using the AF data, the unit tunes in to another frequency broadcasting the same programme as the original preset RDS station is if the preset station signals are not sufficient. MUTING 1/MUTING 2 : Select either one which mutes the sounds while using a cellular phone. LOW PWR : VOL 00 ­ VOL 30 (Select this if the maximum power of the speaker is less than 45 W to prevent them from damaging the speaker. ) : Subject to the interference noises from adjacent stations, but sound quality will not be degraded and maintains the stereo effect. How to clean the connectors frequent detachment will deteriorate the connectors. To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors. If a disc does become dirty, wipe it with a soft cloth in a straight line from center to edge. Do not use any solvent (for example, conventional record cleaner, spray, thinner, benzine, etc. To remove these rough spots, rub the edges with a pencil or ball-point pen, etc. Moisture may condense on the lens inside the CD player in the following cases: · If it becomes very humid inside the car. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates. Do not use the following discs: Warped disc When removing a disc from Center holder its case, press down the center holder of the case and lift the disc out, holding it by the edges. When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up). More about this unit Turning on the power By pressing SOURCE on the unit, you can also turn on the power. On the other hand, NetworkTracking Reception cannot be deactivated without deactivating Alternative Frequency Reception. [. . . ] ­ Discs on which labels can be directly printed by an ink jet printer. Using these discs under high temperatures or high humidities may cause malfunctions or damage to the unit. If you change the source, playback also stops (without ejecting the disc). Next time you select "DISC" for the playback source, disc play starts from where it has been stopped previously. [. . . ]