User manual JVC KD-DV6201

[. . . ] Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel. CAUTION: Visible and invisible laser radiation when open and interlock failed or defeated. Use of this copyright protection technology must be authorized by Macrovision, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision. [. . . ] The source automatically changes to "DISC" when Dual Zone is activated. LOUD (loudness) LOUD ON or Boost low and high frequencies to LOUD OFF produce a well-balanced sound at low volume level. Adjust and store auto-adjustment volume level for each source, comparing to the FM volume level. *1 If you are using a two-speaker system, set the fader level to "00. DEMO ON [Initial] : Display demonstration will be activated automatically if no operation is done for about 20 seconds, [5]. : When the currently received signals become weak, the unit switches to another station or service (the programme may differ from the one currently received), [12]. : When the currently received signals become weak, the unit switches to another station broadcasting the same programme. : Select either one which mutes the playback sounds while using a cellular phone. : The cut-off frequency is chosen automatically according to the WOOFER setting (LOW/MID/HIGH) so that you can enjoy the bass sound purely from the subwoofer if it is connected. : VOL 00 ­ VOL 30 (Select if the maximum power of each speaker is less than 50 W to prevent the speaker from being damaged. ) : Subject to interference noises from adjacent stations, but sound quality will not be degraded and the stereo effect will remain. Some characters or symbols will not be shown correctly (or will be blanked) on the display. Displayed only when one of the following sources is selected--FM, AM, DISC, USB, or LINE IN. These operations are possible on the monitor using the remote controller. Select the monitor type to watch a wide screen picture on your monitor. When playing back a multi-channel disc, this setting affects the signals reproduced through the LINE OUT jacks (and through the DIGITAL OUT terminal when "PCM ONLY" is selected for "DIGITAL AUDIO OUTPUT"). ⷠSURROUND COMPATIBLE : Select to enjoy multi-channel surround audio by connecting an amplifier compatible with Dolby Surround. You can enjoy a powerful sound at low or middle volume levels while playing a Dolby Digital software. Once you have played back a disc in which the Registration Code recorded, this unit's Registration Code is overwritten for copyright protection. ⷠYou cannot assign names to any discs other than conventional CDs. How to clean the connectors frequent detachment will deteriorate the connectors. To minimize this possibility, periodically wipe the connectors with a cotton swab or cloth moistened with alcohol, being careful not to damage the connectors. [. . . ] ⷠEven if "4:3 PAN SCAN" is selected, the screen size may become "4:3 LETTER BOX" for some discs. About sounds reproduced through the rear terminals When playing a multi-channel encoded disc, multi-channel signals are downmixed. Through DIGITAL OUT (optical): Digital signals (Linear PCM, Dolby Digital, DTS, MPEG Audio) are emitted through this terminal. ) To reproduce multi-channel sounds such as Dolby Digital and DTS, connect an amplifier or a decoder compatible with these multi-channel sources to this terminal, and set "DIGITAL AUDIO OUTPUT" correctly. [. . . ]