User manual JVC KD-BT11 INSTALLATION

[. . . ] Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Some Bluetooth devices may not be able to connect to this unit depending on the Bluetooth version of the device. Some operations and display information may be different according to the connected phone. Connecting condition may vary depending on the circumstances around you. If "ERROR" appears again, check if the device supports the function you have tried. If the message does not disappear, turn off and turn on the unit, then connect the device again (or reset the unit). If "PLS RESET" appears again, consult your nearest JVC car audio dealers. *1 When you connect the iPod nano to the interface adapter, be sure to disconnect the headphones; otherwise, no sound is heard. *2 It is not possible to browse video files on the "Videos" menu while the iPod is connected to the interface adapter. If the iPod does not play correctly, please update your iPod software to the latest version. While the iPod is connected, all operations from the iPod are disabled. Notice: When operating an iPod, some operations may not be performed correctly or as intended. Only the primary DAB service can be preset even when you store a secondary service. A previously preset DAB service is erased when a new DAB service is stored in the same preset number. "AUTO" setting for "DIMMER" may not work correctly on some vehicles, particularly on those having a control dial for dimming. In this case, change the "DIMMER" setting to any other than "AUTO. " · If you change the "AMP GAIN" setting from "HIGH POWER" to "LOW POWER" while the volume level is set higher than "VOLUME 30, " the unit automatically changes the volume level to "VOLUME 30. You can control the following types of iPods through the interface adapter. ­ iPod with dock connector (3rd Generation) ­ iPod with Click Wheel (4th Generation) ­ iPod mini ­ iPod photo ­ iPod nano *1 ­ iPod video (5th Generation) *2 What appears to be trouble is not always serious. Finalize the CD-R/CD-RW with the component which you used for recording. Use a disc with MP3/WMA tracks recorded in a format compliant with ISO 9660 Level 1, Level 2, Romeo, or Joliet. A longer readout time is required Do not use too many hierarchical levels and folders. Remedies/Causes The playback order is determined when the files are recorded. [. . . ] To prevent short circuits, cover the terminals of the UNUSED leads with insulating tape. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car. If any item is missing, consult your JVC car audio dealer immediately. [. . . ]