User manual JVC KD-AR5000

[. . . ] Be sure to ground this unit to the car's chassis again after installation. It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 to 8 ). If the maximum power is less than 50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 14 of the INSTRUCTIONS). [. . . ] To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape. DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car. If any item is missing, consult your JVC car audio dealer immediately. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits. If you are not sure how to install this unit correctly, have it installed by a qualified technician. Insert the two handles, then pull them as illustrated so that the unit can be removed. JVC Amplifier Amplificador de JVC JVC Amplificateur Remote lead (blue with white stripe) Cable remoto (azul con rayas blancas) Fil d'alimentation à distance (bleu avec bande blanche) To the remote lead of other equipment or automatic antenna if any Al conductor remoto de otro equipo o de la antena automática, si hubiere Au fil de télécommande de l'autre appareil ou à l'antenne automatique s'il y en a une *2 Before checking the operation of this unit prior to installation, this lead Must be connected, otherwise power cannot be turned on. *3 Firmly attach the ground wire to the metallic body or to the chassis of the Car--to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). If your car is equipped with the steering wheel remote controller, you can operate this unit using the controller. For connection, an exclusive remote adapter (not supplied) which matches your car is required. For details, consult the same car audio dealer as where the unit is purchased. Before connecting the external components, make sure that the unit is turned off. For listening to the SIRIUS Satellite radio, connect a JVC DLP --Down Link Processor (separately purchased) to this unit. [. . . ] Before connecting the external components, make sure that the unit is turned off. For listening to the SIRIUS Satellite radio, connect a JVC DLP --Down Link Processor (separately purchased) to this unit. Player can be connected using an interface adapter (not supplied)--KS-PD100 (for iPod) or KS-PD500 (for D. [. . . ]