User manual JVC CS-AW8540

[. . . ] Cut out the mounting area on the vehicle or board along the marking. Specifications Type : 2-Way Separate Speaker Frequency Response : 45 Hz - 50 kHz Sound Pressure Level : 84 dB/W 0m Recommended Crossover Frequency : 4. 5 kHz (Cut-off Slope:-12 dB/oct. ) 14. 5cm Wood Cone Woofer Power Handling Capacity (Nominal) : 50 W Power Handling Capacity (Max. Music Power) : 150 W Impedance :4K Frequency Response : 45 Hz - 8 kHz Sound Pressure Level : 84 dB/W 0m Mass : 1. 5 kg (one piece) 2cm Wood Dome Tweeter Power Handling Capacity (Nominal) : 50 W (4. 5 KHz -12 db/oct. [. . . ] Each unit, therefore, has a unique appearance. Thiele/ Small Parameter (14. 5 cm Woofer) Revc (DC VC Res ) Imp. (300Hz) Fo (Res Freq ) Zo (Zmax at Fo) Sd (Piston Area) BL (Flux*Length) Qms (Mech Q) Qes (Elec Q) Qts (Total Q) Vas (Acous Vol) Le (Inductance) Cms (Compliance) Mms (Total Mass) 3. 4 4 80. 2 26. 9 0. 0095 6. 08 3. 814 0. 667 0. 568 4. 13 0. 286 321. 9 12. 23 Litr mH uM/N Gram Gram Ohms Ohms Hz Ohm sqM TM Thank you for purchasing the JVC Car Stereo Speakers. For the secure installation and perfect operation of your speaker, please read the following instructions carefully. Mounting the speaker Professional knowledge is required for mounting this speaker. Make use of the paper pattern provided when processing the mounting board of the speaker. During mounting, ensure that there is enough spacing to avoid hitting against any parts such as window glass. In order to optimize the sound field of the wood cone, it is recommended that the speaker terminal be mounted at the bottom with the wood grain in the vertical direction. Notes for dealers Upon completing the mounting, please hand this instruction manual to the customer. For Proper Installation and Use 1. Connection with reversed polarity will degrade the quality of stereo reproduction. Make sure that the output impedance of the amplifier's speaker terminal is rated at 4 ohms. When cleaning the speakers, use a soft cloth and wipe the surface gently. Do not apply thinner or solvent. Mmd (DiaphmMass) 11. 70 INSTRUCTIONS EN 2006 Victor Company of Japan, Limited 0606SKMSANTCN 1005MNMWTNTCN LVT1405-002A [E] Mounting o Tweeter B4 Dimensions o Woofer 134 55. 5 4. 5 HO LE S Unit: mm Mounting area on the vehicle or board 8- 160 A8 Mounting area on the vehicle or board D D Terminal side The protection bars are provided as protection for the wood cone diaphragm. Please use as necessary. o Tweeter 47. 4 44. 2 S LE HO 11. 5 26. 4 69. 5 4. 1 Before connecting Connecting the speaker cords 67 77 54. 3 · Speaker cords are not supplied. o Woofer Loosen o Tweeter 10. 9 18. 1 28. 4 47. 4 Fasten 5. 2mm 2. 8mm Information for Users on Disposal of Old Equipment This symbol indicates that the product with this symbol should not be disposed as general household waste at its end-of-life. [. . . ] If you wish to dispose of this product, please do so in accordance with applicable national legislation or other rules in your country and municipality. By disposing of this product correctly, you will help to conserve natural resources and will help prevent potential negative effects on the environment and human health. 10mm Connection Cut-off frequency: 4. 5 kHz and above -12dB/oct. [. . . ]