User manual JVC 4VN-990

[. . . ] CAUTION (applies to the AA-V37) TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ATTENTION (s’applique à l’AA-V37) POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND. Using This Instruction Manual • All major sections and subsections are listed in the Table Of Contents (੬ pg. • Basic and advanced features/operation are separated for easier reference. It is recommended that you . read thoroughly the Safety Precautions and Safety Instructions that follow. [. . . ] •The camera will continue to focus on the subject while the button is half-pressed. • To display the image on the LCD screen while shooting, press the DSP button. Press the Shutter button all the way for over 1 second to take the picture. • If the flash is set, it will only flash for the first photo. NOTES: ● It is not possible to shoot continuous photos if the uncompressed picture quality is selected. ● The picture appears dark when shooting at dark location inside a room, etc. EN 43 Changing the AE/AF Area Normally, in this camera this setting is “MULTI” in order to prevent the subject from being out of focus while the background is in focus. If the camera does not focus on the point that you want it to, change this setting to “SPOT”. 3, 6 4, 5 2 1 SET M V CAMERA SETTING W. DRIVE OFF AE/AF SPOT CLEAR EXE 1 2 3 4 5 6 Turn the Power dial to “M”. Press the DSP button to turn off the menu screen. NOTE: MULTI: A precise exposure setting is made by dividing the scene into several sections and then measuring the light in each section. SPOT: The exposure is set by measuring the light in a small spot in the center of the scene. Use this mode when you want to shoot a subject with a large difference between dark and bright area, such as someone on a skihill, or someone standing in a spotlight in a darkened theater. ● If “SPOT” is selected for shooting, press the DSP button until “ ” appears on the LCD screen. O 4 FF 44 EN MANUAL SHOOTING (cont. ) Restoring the Default Settings Perform the procedures described below to return the camera settings to the default settings. Confirm that the self timer is set to “1 second“. 4 5 Point the lens at the subject, position yourself, and half-press the Shutter button. •To display the image on the LCD screen while shooting, press the DSP button. •The shoot standby lamp (green) goes off when the shooting has finished. NOTES: ● Due to large memory files created when shooting a picture of uncompressed quality in this mode, it is recommended to use a Memory card with the capacity more than 16MB. ● It takes a few seconds until the shooting finishes because this mode uses the exposure twice. Do not move the object and the camera until the shooting finishes completely. 48 EN MANUAL SHOOTING (cont. ) NR Pro-Still (Noise Reduction Mode) This mode reduces electronic noise in a photograph by layering several copies of the same image. Use a tripod to prevent problems caused by shaky hands. 3 2 4, 5 1 SET O 4 FF M V 1 2 3 Turn the Power dial to “M”. Confirm that the self timer is set to “1 second“. 4 5 Point the lens at the subject, position yourself, and half-press the Shutter button. • To display the image on the LCD screen while shooting, press the DSP button. • The shoot standby lamp (green) goes off when the shooting has finished. NOTES: ● Due to large memory files created when shooting a picture of uncompressed quality in this mode, it is recommended to use a Memory card with the capacity more than 16MB. ● It takes a few seconds until the shooting finishes because this mode uses the exposure 8 times. Do not move the object and the camera until the shooting finishes completely. EN 49 Video Shooting The camera can record a maximum of 20 seconds of video. [. . . ] Print your home return address on the outside and the inside of the carton. Send to the appropriate JVC Factory Service Center as listed above. ACCESSORIES To purchase accessories for your JVC product, you may contact your local JVC Dealer. Or from the 48 Continental United States call toll free: 1-800-882-2345. Don’t service it yourself. CAUTION To prevent electrical shock, do not open the cabinet. Refer servicing to qualified service personnel. WARRANTY (Only in U. S. A. ) LIMITED WARRANTY EN 93 CONSUMER VIDEO 1-90 JVC COMPANY OF AMERICA warrants this product and all parts thereof, except as set forth below ONLY TO THE ORIGINAL PURCHASER AT RETAIL to be FREE FROM DEFECTIVE MATERIALS AND WORKMANSHIP from the date of original retail purchase for the period as shown below. [. . . ]