User manual JURA NESPRESSO N30

[. . . ] For further information concerning the different varieties of Nespresso coffee and to order capsules, contact your Nespresso Club at the address found on your machine or in the «Welcome-pack». Remove the water tank by lifting it out by its lid (1) and fill it with water (2). Applying light pressure to facilitate the opening of the bottom valve, put the water tank back into place (3) and close the lid (4). Since water quality is essential to a good Nespresso, we recommend that you: Clean the tank at least once a week. [. . . ] First prepare a Nespresso in a cappuccino cup filling it only one-third full. Remove the capsule holder from the spout ring, discard the used capsule and reinsert the empty capsule holder in the spout ring. Once the yellow temperature control light goes off, the machine is ready for use. Plunge the steam nozzle into the receptacle and turn the function knob to the position on the left (17). Maintain the end of the nozzle under the surface of the milk during the entire procedure ensuring that it does not touch the base of the receptacle. stop the steam by turning the function knob to the «0» position. The steam nozzle is useful in making frothed milk for a cappuccino, or for heating a liquid. Pour approximately 1 dl of cold whole milk into a sufficiently high pot (of not more than 0. Turn the function knob again to the position on the left for just a second in order to eliminate any residual milk that otherwise can block the steam nozzle. Wipe the steam / hot water nozzle with a clean damp cloth immediately after its use. Important: To extract a Nespresso after having used the steam, let the machine cool down. To do this, insert the empty capsule holder into the spout ring, place a receptacle under the coffee spout and run the equivalent of one or two large cups of water by turning the function knob to the position on the right. Once the yellow temperature control light goes off, the machine is ready for use. You can also heat liquids thanks to the steam / hot water nozzle on this machine. Important: To extract a Nespresso after having used the steam, let the machine cool down. To do this, insert the empty capsule holder in the spout ring, place a receptacle under the coffee spout and run the equivalent of one or two large cups of water by turning the function knob to the position on the right. Once the yellow temperature control light goes off, the machine is ready for use. It is highly recommended that you preheat the cups with very hot water before making the first Nespresso of the day. Subsequent cups can be preheated by stocking them on the cup heating plate. Once the yellow temperature control light goes off, the machine is ready for use. Plunge the steam nozzle into the receptacle containing the liquid to be heated and turn the function knob to the position on the left (18). Maintain the end of the nozzle under the surface of the liquid during the entire procedure ensuring that it does not touch the base of the receptacle. [. . . ] For further information, contact your Nespresso Club who has products specially conceived for this purpose available to you. The machine is delivered with a hexagonal key and cleaning tool that will be useful to you in descaling your machine. Preheat the capsule holder by inserting it empty into the spout ring and running hot water through it (8). To do this, remove the capsule holder from the spout ring, place a receptacle under the coffee spout and turn the function knob to the position on the right. [. . . ]