User manual JUNO JUN 44882

[. . . ] If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. You must read them carefully before installing or using the appliance. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. ⷠThe appliance must not be located close to radiators or gas cookers. [. . . ] The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Pilot light Thermostat knob Super control light Normal/Super push button/ Reset sound signal alarm Warning light Insert the plug into the wall socket. Turn the thermostat knob (B), clockwise, beyond the «1» position. The warning light (E) will blink and the sound signal alarm will get on, indicating that the temperature inside the appliance is too high. Push the button (D), the sound signal alarm will get off and pushing the button a second time the super control light (C) light up. To stop operation, simply turn the thermostat knob to position «O» and a sound is on only for 2 sec . If the quick-freezing function is not ended manually, the appliance switch off the quick-freezing function after 52 hours. The quick-freezing function can be ended manually at any time by pressing the button (D) again. The temperature alarm light blinks automatically whenever the temperature within the freezer rises above a certain value which might endanger satisfactory long-term conservation. It is perfectly normal for the temperature alarm light to remain flashed for a short time after the freezer is initially turned on. It will remain flashed until the optimum temperature for the conservation of frozen food is attained. The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: · This appliance incorporates an alarm which gives off a sound signal when the temperature inside the freezer has risen to a point where the safe storage of frozen food is no longer ensured. The freezer compartment is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods allow it to run on the fast freeze setting for at least 24 hours before loading food. As shown in figure In order to freeze the quantity indicated on the rating plate, arrange the food directly in contact with the cooling surfaces. Important If there is a power failure when food is in the freezer, do not open the door of the freezer compartment. The frozen food will not be affected if the power cut is of short duration (up to 6-8 8 hours) and the freezer compartment is full, otherwise, it is recommended that the food should be used within a short time (a temperature increase of the frozen food shortens its safe storage period). Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. [. . . ] If is necessary that the niche is provided with a ventilation conduct having the following dimensions: Depth 50 mm Width 540 mm Make sure that a distance of 44 mm is maintained in the lower part between the kitchen furniture and the border of the appliance. The lower hinge cover inserted in the accessories bag, is useful to guarantee the exact position of the kitchen furniture and the appliance. Fasten the appliance with 4 screws provided in the kit included with the appliance. From the plastic cover (E), which is used to cover the hinge with the pivot pin, you must take away the part as indicated in the drawing. [. . . ]