User manual JUNO JRG 90181

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. You must read them carefully before installing or using the appliance. [. . . ] Important: if the supply cord is damaged, it must be replaced by a special cord or assembly availa-ble from the manufacturer or its service agent. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. On/OFF light Fridge button ON/OFF Temperature setting button (warmest) Temperature indicator Temperature setting button (coldest) Super cooling light Super cooling button During normal functioning the indicator shows the temperature inside the fridge. OFF: Keep pressed the button (B) until the pilot light (A) and the temperature indicator switches off. Temperature - a new setting has recently been setting buttons selected By pressing the button (C or E), the - the door has been left open for a current temperature setting flashes on long time the indicator. It is possible to modify the - warm food has been placed in the setting temperature only with flashing compartment indicator. The light indicator displays the newly selected temperature for a few seconds and G. Super cooling button then shows again the inside The maximum performance is compartment temperature. obtained by setting the supercooling The newly selected temperature function. During the stability period and when first starting the appliance the temperature displayed does not correspond to the setting temperature. [. . . ] If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. Replace the lamp with one of the same power (the maximum power is shown on the light diffuser). The appliance should be installed If the appliance is not functioning well away from sources of heat such as properly, check that: radiators, boilers, direct sunlight etc. [. . . ]