User manual JUNO JMW2100-B

[. . . ] ⷠThe appliance must not be located close to radiators or gas cookers. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person · This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] Important: if the supply cord is damaged, it must be replaced by a special cord or assembly availa-ble from the manufacturer or its service agent. It is advisable to wait at least two hours Before connecting the appliance to allow the oil to flow back in the compressor. ⷠThere are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. The bottle holder hooked onto one of the internal shelves can be used to store bottles or cans. To remove this holder, lift the back of the shelf, press and pull it out. The glass shelf incorporates a device with slits (adjustable by means of a sliding lever), which makes it possible to regulate the temperature in the vegetable drawer(s). Fruit and vegetables: these should be thoroughly cleaned and placed in the special drawer(s) provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. [. . . ] Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). Separate parts Ha, Hb, Hc, Hd as shown in the figure Fasten the appliance with 4 screws provided in the kit included with the appliance. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). [. . . ]