User manual JUNO JKG2454

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Manufacturers' storage recommendations should be strictly adhered to. During normal operation, the condenser and compressor at the back of the appliance heat up considerably. [. . . ] Do not use detergents which will leave an odour or abrasive powders on the interior, as these will damage the finish. 13 Door reversibility (Fig. Left-hand opening Remove pins (A) and (C) from both sides and the door. Remove pin (D) from the right side. Housing's dimensions Height Depth Width 1225 mm 550 mm 560 mm Instructions for total built-in 50-min. 7 A Push appliance into housing until stop strip (A) touches the kitchen unit. Apply covers (B) on joint cover lugs and into hinge holes. B D015 D353 Fig. 8 A D265 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 5 Position the runners (H) at the top and H bottom of the inside of the kitchen unit as shown in Fig. After preparing the h o l e s , s c re w t h e D094 runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 9 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance D with 4 screws provided in the kit included with the apC pliance. 6 8mm Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 10 PR34 Press in the joint covers between the appliance and the kitchen furniture. Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 15 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner clockwise, beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. However, the thermostat knob setting should be adjusted depending on the temperature required inside the appliance. This, in turn, depends on a number of factors such as the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Turn the knob clockwise, to higher numbers, to obtain a lower temperature, or anticlockwise if a higher temperature is required. Important Do not put carbonated liquids (fizzy drinks, etc. ) in the freezing compartment as they may burst. Water ices, if consumed immediately after removal from the freezing compartment, can possibly cause the skin to be freeze burnt. [. . . ] Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. 16 Internal cleaning Clean the interior periodically with lukewarm water and some bicarbonate of soda; the cabinet exterior with a Silicone wax spray; the condenser and the motor compressor with a brush or a vacuum cleaner. During periods when the appliance is not in use, take the following precautions: unplug the appliance from the power supply; remove all foodstuffs from the appliance; clean the interior and all accessories; leave the doors ajar to facilitate the circulation of air in the interior of the cabinet so as to prevent unpleasant odours from accumulating in the appliance. D411 CUSTOMER SERVICE What to do if the appliance is not functioning properly If something is not working properly, check that: the plug is firmly in the wall socket and the mains power switch is on; there is an electricity supply (find out by plugging in another appliance); the thermostat knob is on the correct position. [. . . ]