User manual JUNO JDL4530W

[. . . ] In this version vapour and fumes will be exhausted on the top of the cupboard where the hood will be mounted through an exhaust pipe with an internal diameter of 120 mm. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. [. . . ] Some carbon filters are supplied wrapped in a plastic film, this to protect their filtering properties, remove this plastic film before fitting the carbon filter. -- The horizontal sections of the pipe must be slanted slightly downwards (about 10%) to ensure the condensed vapour not to come back on the motor of the hood. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (right switch) and one for illuminating the work surface (left switch) . Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. Before performing any maintenance operation, disconnect the hood from the electricity. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. [. . . ] Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. [. . . ]