User manual JUNO JDK8420E

[. . . ] En conditions d'usage normal, il faut le remplacer tous les 6-8 mois. Pour le démonter, enfoncer les touches B vers l'intérieur et le tirer vers le bas (fig. 2). GB Hood Description 1) Motor speed button 2) Light button 3) Operating light 4) Exhaust grate 5) Work-light Recycling version The air is filtered through a carbon filter and recirculated into the room through the grating on the lower chimney part. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. [. . . ] En cas d'utilisation normale, le filtre à graisse doit être lavé une fois par mois au lavevaisselle ou bien avec un peu de savon dissout dans de l'eau tiède; bien laisser sécher le filtre avant de le remonter. Pour le démonter, le pousser vers l'arrière Warning! -- If the hood is run at the same time as a burner or fireplace that depend on ambient air (for example gas, Diesel, coal or wood heaters, water heaters, etc. ) be careful, because the hood, when it exhausts the air, removes the ambient air required by the burner or fireplace for combustion. -- For secure operation and to prevent discharged gas from coming back in, the vacuum must not exceed 0, 04 mbr. This may be done by making sure the air inlet into the room passes through nonclosing openings such as air recycling wall boxes, doors, windows or with other technical measures. -- No food must be cooked flambé underneath the hood. Nettoyage Pour le nettoyage extérieur de la hotte, utiliser un chiffon imbibé d'alcool ou des détergents liquides neutres. Eviter l'usage de tout produit abrasif. Cet appareil est conforme aux normes 87/308/EWG concernant les antiparasites. 14 15 The use of an unprotected flame is dangerous for the filters and could cause fires. When frying foods, never leave the pan alone because the cooking oil could flare up. -- The hood must not be connected to fuel exhaust flues (boilers, heating systems, water heaters, etc. ). -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Fastening the hood to the wall (Fig. 4) -- Position the template in the correct position and make two 8mm diameter holes and two 12mm diameter holes. -- Secure it in place with the two 5x45 mm screws and 5-20 mm diameter washers in the top holes. The screws and washers are standard equipment. using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. -- Before calling for technical service because the light fails to work, make sure the lamps are well screwed. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. This appliance meets 87/308 EWG radio and television noise Standards Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Grease filter This serves to hold the grease particles in suspension. To remove the filter, push it towards the back of the hood and pull it downwards (Fig. To clean, wash it in hot water and biodegradable detergent or in a dishwasher. Clean it at least once a month. Suggestions for the installation and use of the hood -- The horizontal sections of the pipe must be slanted slightly upwards (about 10%) to ensure an easy flow of the air outwards. [. . . ] In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. Installing the duct for recycling version Perform the same operations described in the preceding paragraph. 9). Important Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Fastening of shelves (optional) (Fig. [. . . ]