User manual JUNO JDA3930S

[. . . ] We suggest to use Ø 120 mm exhausting pipe. underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. When frying foods, never leave the pan alone because the cooking oil could flare up. [. . . ] -- Please, keep to the provisions of official directives regarding the question of fume discharge. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. Suggestions for the installation and use of the hood -- The horizontal sections of the pipe must be slanted slightly downwards (about 10%) to ensure the condensed vapour not to come back on the motor of the hood. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. 4 m) and with few curves. Recycling version (filtering) The air is purified by means of a carbon filter and then returned to the room. To install the filter, proceed as follow: fit the filter into its seat B and fix with the two hooks C (fig. 2) can be fitted to the outlet hole using the screws supplied. Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. The hood is supplied with a standard plug; connect it to a correspondingly standard socket. Use the high speed switch only in case of high concentration of vapour. The hood should be switched ON several minutes before you start cooking and should be allowed to run until all the vapours have been eliminated. Speed switch Active Carbon Filter This filter eliminates the odours and vapours which form during cooking. When used in normal conditions it should be replaced at intervals of 6-8 months. These filter can be ordered from the supplier The carbon filter cannot be washed or regenerated. To dismount the filter proceed as follows: Press the two buttons C (fig. 3), pull the filter slightly forwards and remove it. Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Light switch The switching plate is fitted with two switches one for continuous adjustment of the 8 Replacing the lamps -- Disconnect the hood from the electricity. [. . . ] 3), pull the filter slightly forwards and remove it. Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Light switch The switching plate is fitted with two switches one for continuous adjustment of the 8 Replacing the lamps -- Disconnect the hood from the electricity. Push the B knobs inwards toward each other (in the "Open" direction as indicated on the plastic knob itself). [. . . ]