User manual JUNO GSI500B

[. . . ] If the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. Make sure that the power plug is not squashed or damaged by the back of the appliance. [. . . ] Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. ⷠThe appliance must not be located close to radiators or cookers. ⷠMake sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. 1 Temperature regulator Switching on Insert the plug into the wall socket. Switching off To turn off the appliance, turn the Temperature regulator to the "O" position. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. periodic cleaning The equipment has to be cleaned regularly: · Clean the inside and accessories with lukewarm water and some neutral soap. ⷠRegularly check the door seals and wipe clean to ensure they are clean and free from debris. Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. Defrosting of the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ] The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Raise the shelf from the rear and push it forward until it is freed (B). Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. [. . . ]