User manual JUICEMAN JM2000S 10-2009

[. . . ] SAVE THESE INSTRUCTIONS ~ Children should not be left unattended in an area where the appliance is in use. Caution: Do not store items of interest to children in cabinets above the appliance. Children climbing on the appliance to reach these items could be injured. play with or near the appliance. ~ Do not allow children to operate or ~ The appliance is hot during use and remains so for some time after being switched off. [. . . ] The smell will dissipate after a short time and does not indicate a faulty connection or appliance defect. 7 Use Fryer lid ^ To remove the lid to the fryer, press on the left or right side of the lid with your finger a. ^ Use your other hand to lift the cover at the back and remove b. Turning On/Off Do not turn on the fryer when it is empty or when the heating element is raised. ^ To turn the fryer on, press the control knob down and turn it clockwise a to the desired setting. ^ To turn the fryer off, turn the control knob counterclockwise b to "0". , Do not replace the lid until the deep fat fryer is completely cold. Danger of burning. Do not turn the fryer on without pressing the control knob down, and do not turn the knob past "400" to reach "0". After turning the appliance on, the On/Off indicator N and the temperature control light % will turn on. The temperature control light "responds" to the heating element in the appliance, i. e. it only comes on when the fryer is actively heating. 8 Use Residual heat indicator The indicator turns off once the appliance is cool enough to touch. Danger of burns! 9 Using the fryer Before frying Only operate the fryer with the lid removed. If re-using fat which has solidified in the reservoir, make a hole in the fat with a blunt utensil as far down as the heating element. ^ Turn the control knob to 212°F (100°C) and wait until the fat is completely melted. It must be between the minimum and maximum levels as marked on the rear wall of the reservoir. Using the fryer ^ Set the desired frying temperature (see table on next page). ^ Once the water has drained clean the drain valve using a bottle brush. Do not use a stainless steel cleaner in the reservoir. 16 Frequently asked questions Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Possible fault The "Safety cut-out" feature has been activated. If the problem persists contact Miele. What if the oil/fat has an unpleasant odor or smokes when heated?Use oil or fat specifically labeled as being suitable for deep frying. What is the food is not crisp or golden?Solution See "Frying" for more information. 17 Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. Adhere rating label sticker supplied with the appliance below. 18 Technical Service MieleCare (USA only) MieleCare, our Extended Service Contract program; gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability and longevity of your Miele appliance. Please note that unless expressly approved in writing by the Miele Service department, Extended Service Contracts offered by other providers for Miele products will not be recognized by Miele. Our goal is to prevent unauthorized (and untrained) service personnel from working on your Miele products, possibly doing further damage to them, you and/or your home. [. . . ] wok burner and electric cooktop), and they have different minimum safety distances always observe the greater distance. 23 IMPORTANT INSTALLATION SAFETY INSTRUCTIONS Safety distances to the sides of the appliance The fryer should only be installed as shown in the illustrations, while maintaining the required safety distances shown. Do not install the appliance between two tall cabinets, this is a fire hazard. A distance of at least 2" (50 mm) must be kept between the countertop cut-out and the rear wall because of the high temperatures radiated. The minimum distance required from the countertop cut-out to the side wall a: 2" (50 mm) for CS 1112 CS 1122 CS 1212 CS 1221 CS 1223 CS 1326 CS 1411 for CS 1312 CS 1322 CS 1421 CS 1011 CS 1012 CS 1028 2 " (50 mm) recommended 2" (50mm) 1 not recommended 6" (150 mm) 10" (250 mm) for not permitted 24 Installation Safety distance from the wall covering If a wall covering is installed, a minimum safety distance must be maintained between the countertop cut-out and the covering, since high temperatures can damage these materials. [. . . ]