User manual JUICEMAN JM1000M 2009-12

[. . . ] Extension cords do not guarantee the required safety of the appliance (e. g. To guarantee the electrical safety of this appliance continuity must exist between the appliance and an effective grounding system. If there is any doubt, have the electrical system of the house checked by a qualified electrician. damaged it must only be replaced by a Miele Service technician with a genuine Miele power cord. [. . . ] ^ Use one tab or add powder or gel detergent to compartment II and close the flap. ^ If a Pre-rinse is desired, and available for your chosen program, add 1 teaspoon (5 ml) of detergent to compartment I. Compartment I holds a maximum of 2 teaspoons (10 ml), compartment II holds a maximum of 3. 5 tablespoons (50 ml) of detergent. The horizontal marks in compartment II indicate the levels of approximately 1 ¼ and 2 tablespoons (20 and 30 ml) respectively. The marks indicate the approximate fill level in ml when the door is open in a horizontal position. 25 Use Turning on ^ Open the water supply, if closed. The "g" indicator lights up. Selecting and starting a program Choose your program according to the type of load and soiling. Otherwise important program steps may be interrupted. Standby A few minutes after the last key is pressed or at the end of the program the dishwasher will switch into Standby mode to save energy. If refill salt and/or rinse aid or a fault are present in the display, the dishwasher will switch into Standby mode. 26 Use At the end of a program ^ Open the door a few inches to see if the program has finished. In the "Express" program, the drying fan will run for a few minutes after the program is completed. Unloading the lower basket first will prevent water drops from the upper basket and cutlery tray (depending on model) from dropping onto dishes in the lower basket. The dishwasher continues to use electricity until turned off with the "o" button. The "Intake / Drain" indicator flashes when the door is open. Solution ­ Open the water supply. Before fixing the fault: ­ Turn the dishwasher off "o". ­ Clean the water intake filter, see "User Maintenance Instructions". ­ The water pressure at the water connection is lower than 4. 35 psi. See "User Maintenance Instructions" for more info on the above. ­ Remove any kinks in the drain hose. Fault in the water drain. There may be water in the wash cabinet. 32 Frequently asked questions General problems with the dishwasher Possible fault The dishwasher has gone into "Standby" mode to save energy. Detergent is left in the The dispenser was damp dispenser at the end when detergent was added. The door and the interior walls are still It is the normal operating wet after a program mode of the drying system. Remove the residue. The moisture will evaporate after a short time. Clean the drain pump and the non-return valve, see maintenance instructions. [. . . ] In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for the electrical current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is installed and grounded in accordance with all local codes and ordinances. , Improper connection of the equipment grounding conductor can result in electric shock. Do not modify the plug provided with the appliance; if it will not fit the outlet, have a proper outlet installed by a qualified electrician. [. . . ]