User manual JOHN LEWIS JLWD1404

[. . . ] JLWD 1404 1400 spin washer-dryer Instruction manual 30 Minute wash Spin Drain Softeners Rinse Soak 30° Cold 30° 40° Delicates 30° Duvets 40° Cottons Off 90° Economy 60° 60° Economy 40° 40° 30° Drying 60° Economy 40° 40° Easy iron 40° Drying 1400 900 700 500 None Programme time Extra dry Store dry Iron dry Prewash Wash Rinse Rinse hold Drain Spin Drying End Spin Synthetics Prewash Quick Extra Automatic Time dry rinse dry Delay start Start/ Pause Wool JLWD1404 132 987 220 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. Installation This appliance is heavy. [. . . ] To drain the water or to spin see the paragraphs "Draining only" or "Draining and spin" on page 10. Release of the lock is also indicated by the illumination of the "End" light. Turn the programme selector dial to Reset "Off" to switch the machine off. Check whether the drum is completely empty, by rotating it with your hand. The purpose of this is to prevent any items of laundry from remaining accidentally in the drum, where they might get damaged in a subsequent wash (e. g. We advise you to close the water supply tap and disconnect the plug from the socket. Leave the door ajar in order to air the machine. 13 DRYING 3 KG OF COTTON You have for example just machine-washed and spun at 1400 rpm 6 kg of laundry. They are cotton fabrics of medium weight which you want to iron as soon as they are dry. Remove the laundry from the appliance and divide the items to obtain two loads of approx. The water tap must be open and the drain hose must be positioned in the sink or connected to the drain pipe. Turn the programme selector dial to the "Drying" programme for Cottons. If you wish to carry out the electronic drying, depress "Automatic dry" button until the light "Iron Dry" illuminates. Extra dry Store dry Iron dry 5. At the end of the programme turn the programme selector dial to "Off" to switch the machine off. Note: The programme time will automatically increase by up to 1 minute, this is quite normal. For NON-STOP programmes, it is also essential not to exceed the maximum load sizes of 3 kg for cotton and 2 kg for synthetics. You intend to wash and dry automatically 2 kg of synthetics which do not need ironing. Do not use a dosing device/ball when carrying out a washing & drying programme. Switch the machine on by turning the selector dial to a programme for synthetics. If possible, do not select a spin speed lower than that proposed by the appliance to avoid a too long drying time so saving energy. In any case the reduction of the spin speed is only possible after selecting drying. At the end of the programme turn the programme selector dial to "Off" to switch the machine off. During drying the door can only be opened for the first 10 minutes and at the end of drying (after the cooling phase). Automatic dry If you want a timed drying, depress the "Time dry" button until the time you want appears on the display (see page 20). 55 Time dry 4. [. . . ] If the outlet spigot has not been used before, remove any blanking plug that may be in place. Levelling Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable (check diagonally). P1197 P1051 Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is formed in the drain hose (see diagram) to prevent waste from the sink entering the washing machine. Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displacement of the machine during operation. Some vibration is inevitable, especially if mounted on a wooden floor. [. . . ]