User manual JOHN LEWIS JLUCFRW6001

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JOHN LEWIS JLUCFRW6001. We hope that this JOHN LEWIS JLUCFRW6001 user guide will be useful to you.


JOHN LEWIS JLUCFRW6001 : Download the complete user guide (229 Ko)

Manual abstract: user guide JOHN LEWIS JLUCFRW6001

Detailed instructions for use are in the User's Guide.

[. . . ] JLUCFRW6001 refrigerator Instruction manual Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of the these warnings contact the John Lewis branch from which you purchased the appliance. Installation This appliance is heavy. [. . . ] The appliance should therefore: not be installed next to radiators, cookers or other sources of heat only be installed at a location where the ambient temperature corresponds to the climate classification, for which the appliance is designed. Levelling The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance. If required the washer (2) can be removed. Climate Classification The climate classification can be found on the rating plate located inside the appliance. The following table shows the ambient temperature for each climate classification: Climate Classification SN N ST Ambient Temperature +10 to +32 °C +16 to +32 °C +18 to +38 °C 2 1 7 Door Reversal If required the door can be reversed, hinged from the left, opening from the right. To reverse the bottom hinge assembly proceed as follows: Disconnect the appliance from the electricity supply. Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar. transfer the lower door hinge pin to the alternative position as shown in the top drawing. Replace the lower door bracket on the bottom left hand side but do not fully tighten the 3 screws. Remove the fridge door by gently pulling downwards and store to avoid damage. Unscrew the top door hinge pin of the refrigerator then screw it back on the other side. Re-fix the retained screw to the bottom right hand side and replace the 2 adjustable feet. WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. The plug must still be accessible after the appliance has been installed. The appliance should not be connected to the electrical supply by means of an extension cable. Permanent connection In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. Proceed as follows: 1. Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter "E" orthe earth symbol or coloured green and yellow. Connect the Blue (neutral) wire to the terminal in the plug which is marked with the letter "N" or coloured black. Connect the Brown (live) wire to the terminal in the plug which is marked with the letter "L" or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must besecure over the outer sheath. 10 When the refrigerator is first installed General information This appliance is designed for the domestic use only. It has a four-star frozen food compartment for ice making and frozen food storage. Using the Appliance Before Use Remove all packaging and adhesive tape. Wash the inside of the appliance with lukewarm water and bicarbonate of soda (5 ml to 0, 5 litre of water). perfumed cleaning products, wax polishes or products containing alcohol. To Start the Appliance 1. A setting of 3 - 4 is usually suitable for normal operation (see thermostat control). [. . . ] This frost, which acts as an insulator and thus prevents the cold from reaching the food should be removed whenever the thickness of the frost exceeds 6 mm (1/4"). Remove any food from inside the ****-star compartment, wrap it in several sheets of newspaper and store in a cool dry place. To accelerate defrosting, place a bowl of hot water inside the compartment (with a piece of cardboard underneath the bowl as protection). Turn the thermostat knob to a medium position to restart the appliance. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JOHN LEWIS JLUCFRW6001




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JOHN LEWIS JLUCFRW6001 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.