User manual JOHN LEWIS JLFFW2004

[. . . ] JLFFW2004 frost free fridge freezer Instruction manual Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure thatthe book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance andthe relevant warnings. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of the these warnings contact the John Lewis branch from which you purchased the appliance. Installation This appliance is heavy. [. . . ] To display the refrigerator or freezer temperature, press it once or twice, respectively. Function selection/Alarm reset button Used to select the super cooling and shopping modes. The Modes are available as follows, pressing the button once or more times: Normal mode (default) Super cooling mode Shopping mode Normal mode The same button is used to reset acoustic alarm signal, see the description on the display background colour. Refrigerator thermostat knob It is used to set the temperature inside the refrigerator. Putting it into use After connecting to the Electricity supply: Press the "A" button. The backlight of the display turns on. Pressing the "A" button again the appliance is off, but still connected to the mains voltage. 10 The elements of the temperature display are as follows: 1. Refrigerator symbol Dark, when the digits show the refrigerator temperature. Digits By default the digits show the ambient temperature and the ambient symbol is seen. The digits can show also: The medium temperature inside the refrigerator after pressing the "C" button (refrigerator symbol is dark), for a while. The highest temperature inside the freezer after pressing the "C" button twice (freezer symbol is dark), for a while. Refrigerator temperature set (value is blinking) when the "F" knob is rotated and for a while afterwards. Freezer temperature set (value is blinking) when the "B" knob is rotated and for a while afterwards. Super cooling symbol Visible, when the appliance runs in super cooling mode. High temperature symbol Visible, when the temperature in the refrigerator is too high. Shopping symbol Visible, when the appliance runs in shopping cooling mode. See also the chapter on using the refrigerator. Display background colour By default the display background is blue. When ever a control button or knob is used the background turns bright blue and remains so for a while. The display background turns red, if the temperature inside the freezer is too warm (alarm). If this is the case, the digits blink the warmest temperature inside the freezer, the high temperature symbol flashes and an acoustic alarm signal is shown. The temperature might be too warm in the following cases: Immediately after switching on The freezer door was left open for a longer time There is an operating trouble in the freezer To switch the alarm sound off press the "E" button. The display returns to showing the ambient temperature, however the background remains red until the freezer cools down properly. Should you press no button during alarm, press the "E" button when the sound finishes to see the warmest temperature reached during the alarm. Controlling the temperature, setting The Thermostat will stop and start the cooling system as frequently as is required to maintain the temperatures set within the two compartments. Temperature of the refrigerator and freezer can be set by knobs "F" and "B", respectively. The set temperature is seen blinking on the display. [. . . ] Please carry out the following checks before contacting the extended warranty administrators see Repairs - After Sales Service. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom It is too warm in the refrigerator. Cause Thermostatic control can be set incorrectly. The melting water outlet flows not into the evaporative tray above the compressor. [. . . ]