User manual JEUJURA CHALET SUISSE 8045

[. . . ] This product should not be mixed with other commercial wastes for disposal. The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure, that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION - Before using this product read carefully the following safety instructions. Take a look of this manual entirely and preserve it for future reference. [. . . ] This LED has two function: If the PEAK LED lights permanently this means that you have activated the SOLO switch of this channel. If the PEAK LED flashes this means that the input signal is near to the CLIPPING point. IMPORTANT: if the LED PEAK flashes reduce the level of the input signal using the GAIN control. This switch allows you to hear signals through your headphones or control room outputs. Rotate this detented switch to select the preset effect you want to use. Dense, smooth reverb with long tail, long pre delay and some early reflections. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. Dense, smooth reverb with short tail, normal pre delay and increased early reflections. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. LARGE ROOM - This type of reverb reproduces the more intimate ambience of natural room acoustics. The VARIATIONS vary from "bright" (1-8) to "warm" (9-16) starting from long tail to short tail for each one. NOTE: for a correct operation we suggest to choose these three switches (60) or (61) or (62) one at a time. IMPORTANT: these three switches also select which signal is displayed on LED METERS when none channel is soloed. STEREO JACK connector for the headphones output: only stereo headphones with a minimum impedance of 32 Ohms should be connected to this output. These JACK connectors (+4 dB) provide an unbalanced line-level signal and can be used to monitor the MAIN MIX program or as an additional mix output. This jack connector sends out unbalanced line-level signals made of the sum of the input channels' AUX 1 sends, usually for connecting stage monitor amplifiers. This jack connector sends out unbalanced line-level signals made of the sum of the input channels' AUX 2 sends, usually for connecting effect devices or stage monitor amplifiers. This jack connector sends out unbalanced line-level signals made of the sum of the input channels' AUX 3 sends, usually for connecting effect devices. This control ranges from off (0) to +15 dB of gain when fully clockwise (10). This control ranges from off (0) to +15 dB of gain when fully clockwise (10). Balanced jack connectors (0 dB) of the auxiliary stereo input (NOTE: the L input can be used as MONO if R input is left unconnected). This input can be used for the return signal from outboard effects or for connecting any instrument or equipment with a line output. [. . . ] Turn down: the MAIN MIX (83) fader level, the GROUP 1-2 (80) fader level, the C. In your DAW software make sure to set record tracks WITHOUT MONITORING during playback/recording (the method depends by your DAW software). Make sure these switches are UP: 2TRK TO MIX (58), GROUP 1-2 TO MIX (81) otherwise you'll hear feedback when you turn up the MAIN MIX fader later. Set each recording channel's GAIN (4)(25) knobs and LEVEL (21)(41) fader so that you're getting good level without lighting the PEAK indicator on the mixer, also using the SOLO (20)(40) and SOLO MODE (87) PFL and AFL operations. [. . . ]